Installation
| ! Keep this instruction manual in a safe place for future | |
GB | ||
reference. Should the appliance be sold, transferred or | ||
| ||
| moved, make sure the instruction manual accompanies the | |
| ||
| washing machine to inform the new owner as to its opera- | |
| tion and features. | |
| ! Read these instructions carefully: they contain vital | |
| information on installation, use and safety. | |
| Unpacking and levelling |
2.If the floor is not perfectly level, compensate for any unevenness by tightening or loosening the adjustable front feet (see figure); the angle of inclination, measu- red according to the worktop, must not exceed 2°.
Levelling your appliance correctly will provide it with stability and avoid any vibrations, noise and shifting du- ring operation. If it is placed on a fitted or loose carpet, adjust the feet in such a way as to allow enough room
Unpacking |
!This a part of the poly- stirene base and should have stayed intact when you removed the base.
!IMPORTANT check when unpacking your machine.
for ventilation beneath the washing machine.
Electric and water connections
Connecting the water inlet hose
1. Connect the supply pipe by screwing it to a cold water tab using a
3/4 gas threaded connec- tion (see figure).
Before performing the connection, allow the wa- ter to run freely until it is
1.Unpack the washing machine.
2.Check whether the washing machine has been dama- ged during transport. If this is the case, do not install it and contact your retailer.
3. Remove the 4 protecti- ve screws and the rubber bush with the respective spacer, situated on the rear of the appliance (see also the installation leaflet).
perfectly clear.
2. Connect the other end of the water inlet hose to the washing machine, screwing it onto the ap- pliance’s cold water inlet, situated on the top right- hand side on the rear of the appliance (see figure).
4.Do not remove external bar.
5.Seal the gaps using the plastic plugs provided.
6.Keep all the parts: you will need them again if the wa-
shing machine needs to be moved to another location. ! Packaging materials are not children’s toys.
Levelling
Your machine may make a considerable amount of noise if the two front feet have not been adjusted correctly.
1. Install the washing ma- chine on a flat sturdy floor, without resting it up against
walls, furniture cabinets or other.
3. Make sure there are no kinks or bends in the hose.
!The water pressure at the tap must be within the values indicated in the Technical details table (on the next page).
!If the water inlet hose is not long enough, contact a specialist store or an authorised serviceman.
!Ensure that the supply taps are allowing water throu- gh. Old taps may seize in the closed position and thus prevent water reaching the machine.
2