Care and maintenance

		Cutting off the water and electricity
	EN	Cutting off the water and electricity
	EN	supplies
		supplies
		• Turn off the water tap after every wash cycle. This will
		limit wear on the hydraulic system in the machine and
		help to prevent leaks.
		• Unplug the appliance when cleaning it and during all
		maintenance work.
		Cleaning the machine
		The outer parts and rubber components of the appliance
		can be cleaned using a soft cloth soaked in lukewarm
		soapy water. Do not use solvents or abrasives.

Cleaning the detergent dispenser drawer

1	To remove the drawer, press
1	lever (1) and pull the drawer
	outwards (2) (see figure).
	Wash it under running water;
	this procedure should be
	repeated frequently.

To access the pre-chamber:

1.take off the cover panel on the front of the machine by first pressing it in the centre and then pushing downwards on both sides until you can remove it (see figures);

2.position a container so that it will collect the water which

flows out (approximately 1.5 l) (see figure);

3. unscrew the lid by rotating it in an anti-clockwise direction (see figure);

4.clean the inside thoroughly;

5.screw the lid back on;

6.reposition the panel, making sure the hooks are securely in place before you push it onto the appliance.

Caring for your appliance drum

•Always leave the door ajar to prevent unpleasant odours from forming.

Cleaning the pump

The washing machine is fitted with a self-cleaning pump which does not require any maintenance. Sometimes, small items (such as coins or buttons) may fall into the protective pre-chamber at the base of the pump.

!Make sure the wash cycle has finished and unplug the appliance.

Checking the water inlet hose

Check the inlet hose at least once a year. If there are any cracks, it should be replaced immediately: during the wash cycles, water pressure is very strong and a cracked hose could easily split open.