Installation sheet
Proper installation is extremely important for your washer dryer to function correctly. When you first receive your washer dryer remove the box and packing material from the unit and inspect it carefully. If you find damage, immediately contact the delivery company and the company from which the unit was purchased.
STEP 1
PREPARE WASHER DRYER
1.Carefully remove the box and packaging materials from the outside of the washer dryer.
2.The drain hose and the power cord are secured on the back of the unit. Please unstrap them.
3.Unscrew and remove the four shipping bolts from the back of the washer dryer. Remove the four spacers that the bolts were attached to as well. Store these in a safe place in case you need to move the washer dryer in the future.
4.Loosen the two front adjustable legs to the desired level and lock nuts with spanner provided.
STEP 2
INSTALL WASHER DRYER
1.Place the drain hose in the drain. Do not allow the hose to kink or get damaged.
2.Do not install the drain hose into the drain in an
3.For best performance the drain hose should not be restricted in any way.
4.The drain stand pipe should be not be higher than 2.6 ft and not lower than 1.64 ft.
5.Caution must be exercised to avoid collapsing or damaging the drain hose.
6.Strap the drain hose to the stand pipe.
7.Thread the inlet water hose to your cold water faucet connection. Tighten by hand until snug. Turn an additional 2/3rd turn by pliers.
8.Do not OVERTIGHTEN. Make sure the water line connection into the back of the unit is secure.
9.Turn on the cold water supply. Check all connections for leaks.
10.Plug the power cord into a grounded 110V, 60Hz approved electrical service protected by a 10 amp fuse or a comparable circuit breaker. The washer dryer is grounded through the third prong G ( refer to page 7. ).
11.Slide washer dryer into position. Make sure the drain hose remains routed straight
through the clip without collapsing or kinking.
12.Level washer dryer by turning the leveling legs in or out as necessary.
13.Tighten leg lock nuts.
14.The washer dryer must be level on four sides. To properly level use a carpenters level. It is always a good idea to check for level again after the first few washes and
Installation Sheet
Page 5