Whirlpool WGD9450WL Troubleshooting, Special Instructions for Steam Models, Dryer Operation

Page 11

Moving care

For power supply cord-connected dryers:

1.Unplug the power supply cord.

2.Steam models only: Shut off water faucet.

3.Steam models only: Disconnect the water inlet hose from faucet, then drain the hose. Transport hose separately.

4.Make sure leveling legs are secure in dryer base.

5.Use masking tape to secure dryer door.

For direct-wired dryers:

WARNING

Electrical Shock Hazard

Disconnect power before servicing.

Replace all parts and panels before operating.

Failure to do so can result in death or electrical shock.

1.Disconnect power.

2.Disconnect wiring.

3.Steam models only: Shut off water faucet.

4.Steam models only: Disconnect the water inlet hose from faucet, then drain the hose. Transport hose separately.

5.Make sure leveling legs are secure in dryer base.

6.Use masking tape to secure dryer door.

Reinstalling the dryer

Follow the “Installation Instructions” to locate, level, and connect the dryer.

Special Instructions for Steam Models

Water Inlet Hoses

Replace inlet hoses and hose screen after 5 years of use to reduce the risk of hose failure. Periodically inspect and replace inlet hoses if bulges, kinks, cuts, wear, or leaks are found.

When replacing your inlet hoses, record the date of replacement.

To winterize dryer

1.Unplug dryer or disconnect power.

2.Shut off water faucet.

3.Disconnect water inlet hose from faucet and drain.

To use dryer again

1.Flush water pipes. Reconnect water inlet hose to faucet. Turn on water faucet.

2.Plug in dryer or reconnect power.

Changing the Drum Light

The dryer light automatically turns on inside the dryer drum when you open the door.

To change the drum light

1.Unplug dryer or disconnect power.

2.Open the dryer door. Locate the light bulb cover on the back wall of the dryer. Remove the screw located in the lower right corner of the cover. Remove the cover.

3.Turn bulb counterclockwise. Replace the bulb with a 10-watt appliance bulb only. Replace the cover and secure with the screw.

4.Plug in dryer or reconnect power.

TROUBLESHOOTING

First try the solutions suggested here and possibly avoid the cost of a service call...

For additional recommendations, refer to your Installation Instructions.

Dryer Operation

Dryer will not run

Is the dryer door firmly closed?

Was the Start button firmly pressed?

Large loads may require pressing and holding the Start button for 2-5 seconds.

Has a household fuse blown, or has a circuit breaker tripped?

There may be 2 household fuses or circuit breakers for the dryer. Check that both fuses are intact and tight, or that both circuit breakers have not tripped. Replace the fuse or reset the circuit breaker. If the problem continues, call an electrician.

Is the correct power supply available?

Electric dryers require 240-volt power supply. Check with a qualified electrician.

Was a regular fuse used? Use a time-delay fuse.

11

Image 11
Contents Sécheuse Électronique Options Assistance or ServiceU.S.A Your safety and the safety of others are very important Dryer SafetyWhat to do if YOU Smell GAS Quick Start GUIDE/DRYER USE Quick Start Guide Automatic Cycles Automatic Preset Cycle SettingsTips for Getting the Best Performance From Your Steam Dryer CyclesAdditional Features Changing Cycles, Options, and Modifiers Control Lock/UnlockDryer Care Dryer Operation TroubleshootingSpecial Instructions for Steam Models Changing the Drum LightDryer displaying code message Dryer ResultsUnusual sounds No heatLoads are wrinkled Cycle time too shortLint on load Stains on load or drumThis limited warranty does not cover Whirlpool Corporation Laundry WarrantyAu Canada Assistance OU ServiceAux États-Unis Votre sécurité et celle des autres est très importante Sécurité DE LA SécheuseImportantes Instructions DE Sécurité Guide DE Démarrage RAPIDE/UTILISATION DE LA Sécheuse Vapeur illustré Préréglages des programmes automatiques De votre sécheuse à vapeurProgrammes Programmes automatiquesLors de lutilisation de Air Only air seulement Programmes manuelsPréréglages des programmes manuels Air Only air seulementChangement des programmes, options et Modificateurs Caractéristiques supplémentairesNettoyage à chaque charge Entretien DE LA SécheuseNettoyage du filtre à charpie Modification des préréglages de degré de séchageInstructions particulières pour Les modèles à vapeur Nettoyage de lintérieur de la sécheuseRetrait de la charpie accumulée Entreposage ou un déménagementFonctionnement de la sécheuse DépannageLe filtre à charpie est-il obstrué de charpie? Résultats de la sécheuseAF flux dair faible Essayer de résoudre le problème de la façon suivanteCharges froissées Taches sur la charge ou sur le tambourTemps de programme trop court Charpie sur la chargeW10244607B W10244611B SP La présente garantie limitée ne couvre pas