Basic operations
The buttons on the remote control are used to explain most of the operations in this manual. You can use the buttons on the center unit same as on the remote control for operations unless otherwise noted.
IMPORTANT
Before using the remote control for the following
operation,AUDIO
• Set the remote control mode selector to AUDIO.
The buttons described below are used on pages 13 to 15.
| AUDIO |
MUTING | MUTING |
DVD | FM/AM AUX TV SOUND |
Source |
|
selecting |
|
buttons |
|
AUDIO VOL |
|
AUDIO | Remote control |
| |
| mode selector |
ENTER
SCAN MODE
SCAN MODE
TREBLE
DIMMER
SLEEP DIMMER
SLEEP
S.WFR CENTER
Turning the system on/off
On the remote control:
Press 
AUDIO.
On the center unit:
Press 
.
When DVD is selected as the source (see page 14), the following messages will appear on the TV screen.
•“OPEN”/“CLOSE”:
Appears when opening or closing the disc tray.
•“NOW READING”:
Appears when the system is reading the disc information.
•“REGION CODE ERROR!”:
Appears when the Region Code of the DVD VIDEO does not match the code the system supports. The disc cannot be played back.
•“NO DISC”:
Appears when no disc is loaded.
•“CANNOT PLAY THIS DISC”: Appears when unplayable disc is loaded.
NOTE
•The STANDBY lamp goes off when the power is turned on, and the lamp lights when the power is turned off.
•A small amount of the power is consumed even when the power is turned off. This is called standby mode and the STANDBY lamp lights in this mode. Unplug the power cord from the AC outlet to turn the power off completely.
•You can also turn on the system by pressing the following buttons;
•OPEN/CLOSE on the remote control or 0 on the center unit
•One of the source selecting buttons on the remote control
•3 on the center unit. You can use the same buttons on the remote control except after pressing FM/AM.
13