Whirlpool 8535841 For proper drying performance, It is your responsibility to, CSA International

Page 2

Before you begin...

Your safety and the safety of others are very important.

We have provided many important safety messages in this manual and on your appliance. Always read and obey all safety messages.

This is the safety alert symbol.

This symbol alerts you to potential hazards that can kill or hurt you and others.

All safety messages will follow the safety alert symbol and either the word “DANGER” or “WARNING”. These words mean:

DANGER

You can be killed or seriously injured if you don’t immediately follow instructions.

WARNING

You can be killed or seriously injured if you don’t follow instructions.

All safety messages will tell you what the potential hazard is, tell you how to reduce the chance of injury, and tell you what can happen if the instructions are not followed.

WARNING: For your safety the information in this manual must be followed to minimize the risk of fire or explosion or to prevent property damage, personal injury or death.

Do not store or use gasoline or other flammable vapors and liquids in the vicinity of this or any other appliance.

WHAT TO DO IF YOU SMELL GAS

Do not try to light any appliance.

Do not touch any electrical switch; do not use any phone in your building.

Clear the room, building or area of all occupants.

Immediately call your gas supplier from a neighbor’s phone. Follow the gas supplier’s instructions.

If you cannot reach your gas supplier, call the fire department.

Installation and service must be performed by a qualified installer, service agency or the gas supplier.

WARNING

Explosion Hazard

Keep flammable materials and vapors, such as gasoline, away from dryer.

Place dryer at least 18 inches above the floor for a garage installation.

Failure to do so can result in death, explosion, or fire.

For proper drying performance:

The location must provide:

Protection from weather and water: Do not store or use dryer where it will be exposed to water and weather.

Room temperature above 45°F: If room temperature is below 45°F, automatic cycles may not shut off.

Level floor: Maximum slope under entire dryer should not be more than 1 inch. If slope is greater than 1 inch, install Extended Dryer Feet Kit, Part No. 279810. Clothes may not tumble properly and automatic sensor cycles may not operate correctly if dryer is not level.

Sturdy floor to support dryer weight of 175 pounds.

It is your responsibility to:

Observe all governing codes and ordinances.

Check code requirements: Some codes limit or do not permit installation of clothes dryers in garages, closets, mobile homes or sleeping quarters. Contact your local building inspector.

Comply with the installation specifications and dimensions.

Consider spacing requirements for companion appliances.

Properly install dryer.

Check that you have everything necessary for proper installation.

Contact a qualified installer to insure that the electrical and gas installation meets all national and local codes and ordinances.

Exhaust to outdoors: Dryer must be exhausted outdoors to prevent exposure to harmful substances in the gas fuels; to prevent large amounts of lint and moisture from accumulating and to maintain drying efficiency.

This installation must conform with local codes or in the absence of local codes, with the National Fuel Gas Code ANSI Z223.1/NFPA 54 installation codes*.

Copies of the standards listed may be obtained from:

*CSA International

8501 East Pleasant Valley Road Cleveland, Ohio 44131-5575

2

Image 2
Contents Installation Instructions Set to operate on Natural GASIt is your responsibility to Your safety and the safety of others are very importantFor proper drying performance CSA InternationalParts needed for installation Closet/confined area Exhaust dimensionsInstallation Gas supply Power supply cord Ground prongElectrical Requirements Recommended ground methodSupply line requirements Natural GasBurner input requirements Dryer must be exhausted outside Mobile home installation requirementsDryer must be fastened to the floor Preferred Plan the exhaust vent installationDetermine vent length AcceptableIf installing washer and dryer, install dryer first Installation stepsInstall vent system Prepare the dryerTo dryer Position Rigid gas Supply line Make gas connection E. Exhaust dryerClamp Moving dryer to a new location? Snap-Lock fittingsWhirlpool Corporation Benton Harbor, Michigan 49022, U.S.A Lea y conserve estas instrucciones Para funcionar con GAS NaturalPara el debido funcionamiento de la secadora Es su responsabilidadConexión opcional a la secadora Campana exterior de salida de aireLas instalaciones en casas móviles o rodantes requieren GasVista de ConfinadaNo se debe instalar ningún otro FrenteSuministro de gas Método recomendado de puesta a tierraRequisitos de entrada del quemador Gas naturalGas licuado Propano líquido/L.P Requisitos de la línea de suministroExterior de salida de Requisitos del Sistema de salida De aireRequisitos de instalación en una casa móvil o rodante La secadora debe fijarse al pisoPreferido Determine la longitud del conductoLa longitud máxima del sistema de salida de aire depende de AceptablePrepare la secadora Etapas de la InstalaciónInstale el sistema de salida de aire Nivelación de la secadoraAbrazadera de 10,2 cm 4 pulg Conexión del gasSalida de aire de la secadora ¿Va a trasladar de lugar la secadora? Impreso en los EE.UU

8535841 specifications

The Whirlpool 8535841 is a high-quality replacement refrigerator water filter designed to provide clean and fresh drinking water, ensuring that your household stays hydrated with safe water. This filter is compatible with various Whirlpool refrigerator models, making it a versatile choice for those looking to enhance their refrigerator's water filtration system.

One of the standout features of the Whirlpool 8535841 is its advanced filtration technology. This filter uses activated carbon to effectively reduce contaminants such as chlorine, lead, sediment, and other impurities that can affect the taste and smell of your drinking water. With its ability to significantly improve water quality, the Whirlpool 8535841 ensures that every glass of water is crisp and refreshing.

The filter has a long-lasting performance with a lifespan of up to six months or 200 gallons of water, depending on usage and water quality. This durability means less frequent replacements, which not only saves money but also reduces waste. Installing the filter is a straightforward process, ensuring that homeowners can quickly and easily replace their old filters without the need for professional assistance.

Another noteworthy characteristic of the Whirlpool 8535841 is its ability to maintain optimal water flow. Unlike some lower-quality filters that may restrict water pressure, this filter is designed to provide an uninterrupted supply of clean water. This efficient performance is crucial for families that rely on their refrigerator for ice and chilled water, ensuring that there is always plenty of clean drinking water available.

Moreover, the Whirlpool 8535841 is NSF-certified, meaning it meets strict safety and performance standards. Consumers can have peace of mind knowing that this water filter has undergone rigorous testing to confirm its efficacy in reducing harmful contaminants. The certification serves as a testament to the high quality and reliability of the product, making it a trusted choice for many households.

In summary, the Whirlpool 8535841 water filter offers advanced filtration technology, ease of installation, long-lasting performance, and reliable water flow. With NSF certification to back its effectiveness, this filter is an excellent investment for anyone looking to improve their drinking water quality while enjoying the convenience of a refrigerator-based filtration system. Whether for health concerns or the simple desire for better-tasting water, the Whirlpool 8535841 stands out as a top choice in refrigerator water filtration solutions.