Whirlpool 8577194 manual RemovingAccumulatedLint, VacationandMovingCare, ChangingtheDrumLight

Page 24

RemovingAccumulatedLint

From Inside the Dryer Cabinet

Lint should be removed every 2 years, or more often, depending on dryer usage. Cleaning should be done by a qualified person.

From the Exhaust Vent

Lint should be removed every 2 years, or more often, depending on dryer usage.

VacationandMovingCare

Vacation care

Operate your dryer only when you are at home. If you will be on vacation or not using your dryer for an extended period of time, you should:

1.Unplug dryer or disconnect power.

2.Clean lint screen. See “Cleaning the Lint Screen.”

Moving care

For power supply cord-connected dryers:

1.Unplug the power supply cord.

2.Make sure leveling legs are secure in dryer base.

3.Use masking tape to secure dryer door.

WARNING

Electrical Shock Hazard

Disconnect power before servicing.

Replace all parts and panels before operating.

Failure to do so can result in death or electrical shock.

For direct-wired dryers:

1.Disconnect power.

2.Disconnect wiring.

3.Make sure leveling legs are secure in dryer base.

4.Use masking tape to secure dryer door.

ChangingtheDrumLight

The dryer light automatically turns on inside the dryer drum when you open the door.

To change the drum light

1.Unplug dryer or disconnect power.

2.Open the dryer door. Locate the light bulb cover on the back wall of the dryer. Remove the screw located in the lower right corner of the cover. Remove the cover.

3.Turn bulb counterclockwise. Replace the bulb with a 10-watt appliance bulb only. Replace the cover and secure with the screw.

4.Plug in dryer or reconnect power.

24

Image 24
Contents Electronic Electric Dryer 8577194Table of Contents Dryer Safety Your safety and the safety of others are very importantInstallation Instructions ToolsandPartsOptions Dryer Dimensions Installation clearancesLocation Requirements You will needMinimum installation spacing for cabinet installation Mobile home Additional installation requirementsMobile home installations require Closet installation, with stacked washer and dryerElectricalRequirements It is your responsibilityElectrical Connection Power Supply Cord Direct Wire Style 1 Power supply cord strain reliefElectrical Connection Wire connection Power supply cord Style 2 Direct wire strain reliefWire connection Direct wire Remove center silver-colored terminal block screwBDE CG F Optional 3-wire connection If using an existing vent system VentingRequirementsIf this is a new vent system Vent material Optional exhaust installations Alternate installations for close clearancesPlan VentSystem Install VentSystem Install LevelingLegsSpecial provisions for mobile home installations Vent system chartCompleteInstallation ConnectVentLevelDryer If the dryer will not start, check the followingDryer USE StartingYourDryerTo use an Automatic Cycle PausingorRestarting StoppingYourDryerControlLocked DryingandCycleTipsStatusLights Cycles Additional Features TemperatureWhen using Air Only SignalsRack Dry Setting Temp Time Wool Sweaters DryingRackTo use the drying rack Stuffed toys or pillowsCleaningtheDryer Location CleaningtheLintScreenCleaningtheDryerInterior Dryer CareRemovingAccumulatedLint VacationandMovingCareChangingtheDrumLight Troubleshooting DryerOperationCycle time too short Lint on loadStains on load or drum Loads are wrinkledAssistance or Service If you need replacement partsFor assistance and service Accessories U.S.AWhirlpool Dryer Warranty Whirlpool Corporation will not pay for8577194