Operatingexternalcomponentswith the remote control
I
I The buttons described below are used on pages 14 and 15. I
DBS
VCWDBS
•Tosetthe manufacturer'scode
1 Slide the remote control mode selector to TV.
VCR
0/I VCR/DBS
2Press and hold ©/I TV.
®®...... B Oil TV
Keep the button pressed mrtil step 4 is finished.
Number ®® buttons
TV
TW
ill m
loo+
Remote control mode
selector
TV VOL
3Press ENTER.
4Press number buttons
the manufacturer's code (2 digits).
Examples:
For a Hitachi TV: Press l, then 0.
For a Toshiba TV: Press O, then 8.
Manufacturer | Code | Manufacturer | Code |
]VC | 01" | Samsung | 12 |
Hitachi | 10 | Sanyo | 13, 14 |
Magnavox | 02 | Sharp | 06 |
ENTERTVVOL+_
RE( | II |
(play button)
NOTE
•Manufhcturers' codes are subject to change without notice.
•get the codes again after replacing the batteries of the remote control.
Mitsubishi | 03 | Sony | 07 |
Pmlasonic | 04, 11 | Toshiba | 08 |
Philips | 15 | Zenith | 09 |
RCA | 05 |
|
|
*"0l" is the initial setting.
5 Release ©/I TV.
If there is more than one code listed for corresponding brand, try each one until you enter the correct one.
•Operation
Aim the remote control at the T\(
IMPORTANT
Be_re using the remote control to operate a TV;
• Set the remote control mode selector to TV.
The %llowing buttons are available: |
| ||||
©/I | TV: | Turns TV on and | oK | ||
TV VO k | Adjusts | the | volume. | ||
TV/VIDEO: | Selects | the | input mode (either TV or | ||
|
| VIDEO). |
|
|
|
CH | Changes | the channels. | |||
O, > 10 (100+): | Selects | the | channel. |
| |
TV RETURN: | Alternates | between | the previously selected | ||
|
| channel and the current channel. |
NOTE
•The operating buttons may difi%rdepending on manuihcturers.
14