Lint | screen |
|
| |
|
| The | lint screen | |
|
| is inside | the dryer | |
|
| drum, | on | the |
|
| back | wall. Clean | |
|
| it before | each | |
|
| load. | A screen | |
|
| blocked | by lint | |
Pull | straight | can increase | ||
| out. | drying | time. | |
1.Use the finger holes to pull the lint screen straight out.
2.Lightly squeeze the body, as shown, while pulling the cover off.
3.Roll lint off the screen with your fingers. DO NOT rinse or wash the screen. Wet lint is hard to
remove. | Squeeze | body; |
| ||
| pull cover | off. |
4.Replace the cover on the body of the lint screen.
5.Push the lint screen straight back in until it clicks into place.
Lint removal
Lint can gather inside the dryer and create a FIRE HAZARD. this lint should be removed at least every 2 to 3 years, or more often, depending on dryer usage.
ELECTRIC DRYERS | GAS DRYERS |
eaning should be done only by a qualified person.
1. Remove back panel (electric) or lower access panel (gas].
2. Avoid damaging wires, thermostats, funnel or igniter.
3. Remove lint from shaded area - see
4. Replace panel; reconnect and