Whirlpool 3397617 Attach U.1, Relief Hole, Tighten, Strain relief firmly to strain relief, Ror

Mobile home or other four-wire installations:

Electrical Shock Hazard

Check that wiring you are using matches colors shown in illustrations and specified in instruction steps. If wiring does Not match, it is your responsibility to have a qualified electrician install the correct wiring.

Failure to install the correct wiring could result in death or serious injury.

1 . Turn power supply off.

2 . Remove hold-down screw and terminal block cover.

hold- down screw

				Figure	14
3 . Attach			3/4” U.1
listed	strain		relief
(U.L. marking				on
strain	relief)		to	the
hole	below				I
terminal		block		”
opening		(see			power
					roJgIY
Figure		15).	Tighten
strain relief firmly to strain relief
cabinet		SO	it iS in 0		(outside dryer)
horizontal position.					Figure 15
Place		power
supply		cord
through		strain		relief.

a. Remove the center terminal )lock screw. Remove the neutral lreen with yellow stripe grounding vire from external grounding zonnector screw. Connect neutral Ireen with yellow stripe grounding vire and the neutral wire (white or :enter) of power supply cord under he center screw of terminal block.

Connect the other two insulated vires under outer terminal block crews.

Connect the green, grounding wire rom the power supply cord to the external grounding connector

crew (see Figure 16).

‘ighten all terminal block screws irmly.

external					green	with
					yellow
grounding
					stripes
:onnector
		\			(attached
ing		b$		%	bt factory)
err....			.	II
minnlc						I
					+,,enter	(
					fiLscrew	I
Ireen
vire
ror-
black	/

strain relief

Figure 16

5. Tighten strain relief screws.

6. Insert tab of terminal block :over into slot of the dryer rear lane1 (see Figure 14). Secure cover Nith hold-down screw.

1 . Turn power supply off.

2 n Strrp 5 inches (12.7 cm) of outer covering from end of cable. Leave bare grounding wire at 5 inches (12.7 cm). Cut l-l /2” (3.8 cm) from 3 remaining insulated wires. Strip insulation back 1 inch (2.5 cm) (see Figure 17).

3-112”

3/4” U.L.- /+- (e.9 cm),;;r

disconnect	/	(white
			stripped of
		y*;,
grounding		5”	(12.7 cm) +
wire(Romex)
			7
Direct		wire preparation
		Figure	17

u-shapedShape the end of

hook each wire into a ‘U” shaped hook

(see Figure 18). The bare grounding wire

must be 4-l /2” Figure 18 (11.4 cm) long

after forming the hook.

3 . Remove hold-down screw and terminal block cover,

external

			Figure1 9
4 . Attach		3/4’		rear
U.L.-listed strain
relief (U.L.
marking	on
strain relief)		to
the hole	below
terminal	block
openina	(see
Figure 2%).				str&n relaf
Tighten	strain
				(outside dryer)
relief firmly		to		Figure 20
cabinet	so it is

in a horizontal

position. Place power supply cable through the strain relief.

Page 6