Kenwood IC450, IC400 manual Safety, Before plugging, Important UK only

Page 5

safety

Never unscrew the boiler cap whilst the unit is pressurised. Steam will shoot out and burn you.

Don’t get burnt by the iron’s steam, hot water, soleplate or iron rest.

Keep children away from the steam station. And make sure they can’t grab the cords and pull the steam station down.

Trailing cords are a hazard, keep them out of the way to prevent accidents.

Never iron clothes being worn.

Never put the steam station, cord or plug in liquid – you could get an electric shock.

Always switch off and unplug the steam station before removing the boiler cap and filling with water.

Don’t let the power and steam supply cords touch hot parts.

During ironing pauses and after use always place the iron flat on the iron rest of the steam station.

Never leave the steam station on unattended.

Never use a damaged steam station. Get it checked or repaired: see ‘service and customer care’.

Do not use the steam station if it has been dropped, or if there are any visible signs of danger or it is leaking.

Don’t touch the appliance with wet or damp hands.

Always unplug the steam station when not in use and allow to cool before moving or cleaning.

It is extremely dangerous to direct the steam towards people or animals.

Only use water with this appliance.

During use, the steam station must be stable and used in a horizontal position.

This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction concerning use of the appliance by a person responsible for their safety.

Children should be supervised to ensure that they do not play with the appliance.

Only use the appliance for its intended domestic use. Kenwood will not accept any liability if the appliance is subject to improper use, or failure to comply with these instructions.

before plugging in

Make sure your electricity supply is the same as the one shown on the underside of the steam station.

Important – UK only

The wires in the cord are coloured as follows:

Green and Yellow = Earth, Blue = Neutral,

Brown = Live.

The appliance must be protected by a 13A approved (BS1362) fuse.

WARNING: THIS APPLIANCE MUST BE EARTHED.

Note:

For non-rewireable plugs the fuse cover MUST be refitted when replacing the fuse. If the fuse cover is lost then the plug must not be used until a replacement can be obtained. The correct fuse cover is identified by colour and a replacement may be obtained from your Kenwood Authorised Repairer (see Service).

If a non-rewireable plug is cut off it must be DESTROYED IMMEDIATELY. An electric shock hazard may arise if an unwanted non-rewireable plug is inadvertently inserted into a 13A socket outlet.

2

Image 5
Contents Kenwood Limited, New Lane, Havant, Hampshire PO9 2NH, UK IC400 series IC450 series Page Ssiona profe Important UK only SafetyBefore plugging Before using for the first time Using your steam stationKnow your Kenwood steam station Filling with waterChoosing the right temperature Setting the temperatureHints Dry ironingPtfe soleplate model IC450 only Care and cleaningGuarantee UK only Service and customer careYou supply your receipt to show when you bought it Outside soleplate