Problem Solving, Problem Cause Solution | HoMedics PS-150 instruction

Problem Solving

PROBLEM	CAUSE	SOLUTION

There is no steam	Steamer not plugged in	Plug into electrical outlet

	ON/OFF switch not in	Remove the steam nozzle and hang on door
	“ON” position	hook. Push the switch to the “ON” position.
		Switch will illuminate.

	Water tank is low or	Check water tank to be sure it is full. See Filling
	empty	the Water Tank on page 5.

	The hose is kinked	Be sure the steam hose is fully extended.

There is low or	Mineral build-up	Follow the Removing Mineral Build-Up procedure
intermittent steam		on page 9.

	Water tank is low	Check water tank to be sure it is full. See Filling
		the Water Tank on page 5.

Water runs through	Condensation in steam	Hold the hose vertically to allow the water to run
the steam holes in the	hose	back into the water tank.
nozzle
	The steam hose and	Hold the hose vertically to allow the water to run
	nozzle are not being	back into the water tank.
	used in a a vertical
	position

Nozzle gurgles	Condensation in steam	Hold the hose vertically to allow the water to run
	hose	back into the water tank.

The steamer takes a	Mineral build-up	Follow the Removing Mineral Build-Up procedure
long time to heat		on page 9

	The water tank is filled	Unplug the steamer, allow it to cool for 30
	above the fill line	minutes, remove the steam hose and empty the
		water water tank to the maximum fill line.