REMOVING THE MINERAL BUILD-UP
One common problem with steamer is mineral
The procedures below can be used to reduce mineral
1.Turn the unit off and unplug the power cord.
2.Remove the hose and pole from the unit.
3.Drain the water reservoir and empty water from the water tank.
4.Mix a solution of 50% vinegar and 50% water. In most cases, 2 cups of this solution will be sufficient.
5.Slowly pour the
6.If standing the
7.Allow standing for 40 minutes.
8.Drain the solution out of the water reservoir by removing the drain plug and allowing the liquid to drain into a sink or tub.
9.Drain the solution out of the hose connector by tilting the unit over a sink or tub and pouring the water out of the hose connector.
10.Pour clean water in the hose connector and water reservoir inlet and drain. Repeat this step until the vinegar odor dissipates.
11.Reassemble the unit and operate normally.
Problems and Solutions
PROBLEM | REASON | SOLUTION |
The unit fails to | Steamer is not plugged | Plug into electrical outlet. |
steam. | in. |
|
Two Indicating | Household Circuit | Check the power outlet. If you |
lamps do not | Breaker/Ground Fault | need assistance, contact a |
illuminate. | Interrupter is tripped or | qualified electrician. |
| Fuse is blown. |
|
The unit fails to | Mineral | Follow the Removing |
steam. | unit. | Mineral |
Two Indicating | The Water Tank is | Refill the Water Tank. |
lamps illuminate. | empty. |
|
11