FujiFilm Zoom Date 160ez owner manual Trouble Shooting, During operation

Trouble Shooting

During operation

Problems	Possible Causes		Solutions	See Page
The shutter can-	q Is “	” blinking on	q Replace with the new	13
not be released.	the LCD?		battery.	13
	w Doesn’t the power turn		w Press the POWER button.
	on?		e The flash is charging.	21
	e Is “f” blinking on the
	LCD?		Wait until “f” stops blink-
			ing (The flash takes
			about 6 seconds to
			charge).	17
	r Is “´” displayed on the		r Take out the film, and
	picture counter?		load an unused film.	39
	t Is the AF lamp blinking in		t Taking pictures at 0.65 –
	the q mode?		1.3m (2.1 – 4.3ft.) or use
			the AF lock so that the
			AF lamp lights up.
After loading the	/Is the film pulled out to		/Adjust the film length so	18
film and closing	the FILM TIP mark? Is it		that the film tip is at the
the camera back,	pulled out beyond the		FILM TIP mark, and load
“´” blinks.	FILM TIP mark?		the film again.
After loading the	/Did you open the camera		/Check that the motor has	25
film and closing	back so as to take out the		stopped and that “´” is
the camera back,	film without checking that		displayed. After that,
the film is	the motor has stopped		open the camera back
rewound and “´”	and that “´” is dis-		and take out the film.
is displayed.	played?
The film is	/Did you press the n		/Be sure not to press the	26
rewound during	button while the film in		n button while the film
photographing.	mid-roll was loaded in the		in mid-roll is loaded in the
	camera?		camera.
The picture	/Did you take out the film		/After taking out the film,	27
counter blinks.	in mid-roll without rewind-		remove the battery, press
	ing?		the POWER button, and
			check that the picture
			counter is no longer dis-
			played. Then load the
			battery again.

42