Cleaning, Troubleshooting, Technical Data

Cleaning

Self-cleaning function

•Fill the water container up to the marking MAX.

•Insert the plug into the power socket.

•Set the temperature regulator a to the position MAX.

•Let the iron warm up till the control light w cuts off and lights up again.

•Hold the iron horizontally over a trap vessel.

•Set the steam regulator u to Self-Clean position and hold it in this position. Now steam and boiling water will start emerging from the steam escape holes at the gilding sole r. Any dirt, if present, will get washed out.

•Release the steam regulator u as soon as the water in the water container is used up.

•To ensure that no water remains in the steam chamber, dry the gilding sole r thoroughly. For this purpose, wipe the gilding sole r a few times on a towel or an old cloth.

•Allow the iron to cool down before storing it away.

Note:

The effect of the self-cleaning function can diminish after extended usage of the iron. We therefore re- commend the addition of decalcification agent into the water tank.

Casing

Danger of injury!

Pull the mains power plug before cleaning. There is a risk of electrical shock! Allow the device to cool off. Danger of burning!

•Clean the casing only with a soft dry cloth.

•Do not use aggressive or chemical cleaning agents.

Metal Parts

•Clean the metal parts with a cloth slightly moistened with water and a mild, non-foaming cleaning agent.

Troubleshooting

The steam iron puts out only little or no steam

The water reservoir in the steam iron is empty. Fill the water reservoir with tap water (see "Filling with Tap Water“).

The steam iron does not get hot

The steam iron is not plugged in or not switched on. Plug the power plug into the power socket and set the temperature control a to the desired temperature.

The steam iron is defect. Have the defect steam iron repaired by qualified technicians.

Technical Data

Power Supply Voltage: 230 V~/50 Hz

Power:

1200 W

- 5 -