Specifications
Power Source | 110/120 Volts, 60 Hz |
Horsepower | 1/4 HP |
Max. Operating Pressure | 140 PSI |
Recommended Operating Pressure | 100 PSI |
Air Inlet / Outlet | 1/2” Steel Pipe |
Flow Capacity | 21.6 C.F.M. |
Pressure/Temperative Range | 32 - 39 PSI |
For |
|
Note: This Compressed Air Dryer uses
Note: Not for medical use. Do not use for hyperbaric chambers.
Save This Manual
You will need the manual for the safety warnings and precautions, assembly instructions, operating and maintenance procedures, parts list and diagram. Keep your invoice with this manual. Write the invoice number on the inside of the front cover. Keep the manual and invoice in a safe and dry place for future reference.
Safety Warnings and Precautions
WARNING: When using tool, basic safety precautions should always be followed to re- duce the risk of personal injury and damage to equipment.
Read all instructions before using this tool!
1.Keep work area clean. Cluttered areas invite injuries.
2.Observe work area conditions. Do not use machines or power tools in damp or wet locations. Don’t expose to rain. Keep work area well lighted. Do not use electrically powered tools in the presence of flammable gases or liquids.
3.Keep children away. Children must never be allowed in the work area. Do not let them handle machines, tools, extension cords, or air hoses.
4.Store idle equipment. When not in use, tools must be stored in a dry location to inhibit rust. Always lock up tools and keep out of reach of children.
5.Use the right tool for the job. Do not attempt to force a small tool or attachment to do the work of a larger industrial tool. There are certain applications for which this tool was designed. It will do the job better and more safely at the rate for which it was intended. Do not modify this tool and do not use this tool for a purpose for which it was not intended .
6.Dress properly. Do not wear loose clothing or jewelry as they can be caught in moving parts. Protective, electrically
7.Use eye and ear protection. Always wear ANSI approved impact safety goggles. Wear a full face shield if you are producing metal filings or wood chips. Wear an ANSI approved dust mask or respirator when working around metal, wood, and chemical dusts and mists.
REV 07/03; 08/03; 01/05; REV 11/05; REV 09/06
SKU 40211 | For technical questions, please call | Page 2 |