Warning:The warnings, cautions, and instructions discussed in this instruction manual cannot cover all possible conditions and situations that may occur. It must be under- stood by the operator that common sense and caution are factors which cannot be built into this product, but must be supplied by the operator.
Unpacking
When unpacking, check to make sure the parts listed on page 9 are included. If any parts are missing or broken, please call Harbor Freight Tools at the number on the cover of this manual as soon as possible.
Tool
Air Dryer
Compressor
For best service you should incorporate an oiler, regulator, and inline filter, as shown in the diagram above. Hoses, couplers, oilers, regulators, and filters are all available at Harbor Freight Tools.
Note: You will need to prepare valves and couplers (not included) from the compressor to the Air Dryer (1/2” Steel
Installation
1.Install the Air Dryer at least 2 feet from the wall on all four sides. This will give the unit proper ventilation and allow space for maintenance and repair.
2.Make sure the floor is level.
3.Do not expose the unit to rain or any moisture.
4.Install the unit out of direct sunlight and away from any heat sources. Otherwise, the cooling function of the unit will continually run, eventually overheating the Air Dryer.
5.Position a small bucket to capture foul water from the drain hose at the bottom of the unit. Condensation water can be piped to a floor drain, if available; be sure to follow local plumbing codes.
Note: Electrical installation and installation of a recommended bypass valve (not included) are covered on page 5.
SKU 40211 | For technical questions, please call | Page 4 |