Set Up
For smaller items, place the item directly over the Wind Tube (17). Pull the wrist area of gloves up over the gloves to prevent them from restricting airflow.
For tall items, such as boots, set up the two Long Tubes (2) as follows:
a. Slide the Short Tube (1) inside the large end of the Long Tube (2).
b. Fit the Toe Support (3) onto the remaining end of the Long Tube, sliding the Tube edge into the slot on the Toe Support.
c. To Safely balance the unit, slide the Tube assemblies over diagonally opposite Wind Tubes (17). The Short Tube holes are off center, so check to make sure that the thinner side of the tube is closest to the center of the unit so you will have plenty of room to slide the boot in place.
d. Slide the boot over the Tube assemblies, making sure that the entire unit is balanced so it will not tip over during use.
Operation
1.Place the dryer on a flat, level surface. Set the control knob to the off position.
2.Plug the unit into a 120V outlet.
3.Select Heat or No Heat with the Heat Switch (14).
4.Set the Control Knob (13) to the desired drying time. To set the time to less than one hour, turn the Knob past the one hour mark, then return it to the desired time.
5.When the items are dry, remove them, unplug the unit and store in a dry location away from children.
Note: Drying time will vary depending on temperature and humidity.
Smaller items will dry faster than larger items.
Footwear should be dried after every use to prevent bacteria or fungus growth.
SKU 67326 | For technical questions, please call | Page 5 |