Miele T1526 To select a program, To change a program during drying, Correct procedure

Page 11

Program selection

To select a program

Press the "On/Off" button.

Set the desired program by turning the program selector either clock- wise or counterclockwise.

Press the "Start" button.

The program status will be stored for 30 minutes in the event of a power failure.

The program is canceled if:

–There is a power failure lasting more than 30 minutes.

–The door is opened after the ma- chine has entered the "Cooling down" or "Anti-crease" stage.

To change a program during drying

Set the program selector to the desired program.

The new program will start from the be- ginning.

The tables on the following pages list the range of applications for the differ- ent programs.

Correct procedure

1Press the "On/Off" button.

2Press the "Door" button.

3Open the door and load the machine.

4Close the door with a firm swing - do not push it shut.

5If drying delicate fabrics, press the "Low temp." button.

6Select the "Buzzer" if so desired.

7Select a program.

8Press the "Start" button.

After the program has finished

1Set the program selector to "Finish".

2Remove the laundry.

3Clean the lint filter.

4Turn off the machine.

11

Image 11

Contents Operations Manual For the T 1526 Vented Dryer Contents Guide to the machine Pushbuttons Indicator lampsImportant Safety Instructions Important Safety Instructions Disposal of your old machine Your contribution to the environmentDisposal of the packing ma- terial Loading and unloading the machine Page Program selection Program Sequence indicatorsDrying Stage Reached indicators Program Setting selec- torTo change a program during drying Correct procedureProgram is canceled if To select a programPrograms Warm Drying stageNormal + Hand ironCleaning the dryer Cleaning and careCleaning the lint filter Problem solving guide To function? Event of a power Failure?What to do if, . . . ? Cause Remedy Ing the drying cycle?To open the door in the event of a power failure Specimen After-sales serviceThis appliance must be grounded Electrical connectionWhere to install the machine InstallationExhaust venting When installing, try to avoidInstallation at the rear Installing the connector on the left side of the machineType of bend Angle Radius in mm Additional duct Tabel To calculate the effective duct lengthEffective duct ExampleResult Dryer-side view Wall vent kit exampleDryer-top view Wire spiral-wound hose Technical data Load Consumption dataCottons Permanent Press