Drain Hose Fitting Instructions | Hoover DYC 893B instruction

DRAIN HOSE : FITTING INSTRUCTIONS

To avoid emptying the water container after each drying cycle, the water can be discharged directly to a waste water drain pipe (the same drainage system as household sinks). Water Bye-Laws prohibit connection to a surface water drain. The waste water drain pipe should be located adjacent to the tumble dryer.

The kit consists of:1 hose and 1 tap.

WARNING! Switch off and remove the tumble dryer plug from the electricity supply before carrying out any work.

Fit the Hose as Follows:

1.Tilt the machine backwards.

2.The waste water pipe is situated at the left -hand side of the machine (see the picture). A grey hose connects to the bridge at the left hand side of the machine. Using pliers, remove the pipe retaining clip from the bridge.

3.Pull the hose off the bridge connection.

4.Attach the black hose from the kit, (using the connector

a n d p i p e c l i p s supplied), to the hose removed from the bridge connection.

5 . P l a c e t h e t a p supplied by the kit to close the remaing hose.

6.Once the machine is in place the feet should be adjusted to ensure that the new hose does not kink when pushing the tumble dryer into position.

7.Connect the new drain hose to the waste Water pipe.

8.Connect to the m a i n s e l e c t r i c i t y supply.

EN 6