Hoover DYC 893B manual Controls and Indicators

Page 8

CONTROLS AND INDICATORS

Programme

Empty Water

Filter Care

Program

Start/Pause

Selector

Indicator

Indicator

Display

Button

Time Selection

Delay Start

Acrylic Synthetic

Anti-Crease

Button

Button

Button

Button

Control Panel and Indicator Lights

Programme Selector – Select the required programme

Time Selection Button – Allows the user to change duration of the programme selected by Programme Selector. It can be used only with the selection of: Mix&Dry, Shirts and Time Programmes

Delay Start Button – Allows the user to delay the start of the drying cycle (see details of Operation )

Acrylic and Synthetic Button – When pressed the default indicator will fade and will be illuminated

Anti- Crease Button – Allows the user to select a post drying anti-crease cycle. Start/Pause Button – Press to commence/ to pause the selected drying programme.

Memo Button – Allows user to record the programme by pressing simultaneously the Anti-

Crease and the Acrylic Synthetic buttons for 3 seconds, after 2 minutes duration of the chosen

programme/option

Filter Care indicator – lights when the filter needs cleaning Empty Water indicator – lights when the water container is full

Program Display – Related indicator lights when a auto programme has been selected. - Indicator will come on when the eco programme has been selected.

Refresh – The indicator lights up when the programme starts the cool down stage.

SELECTING THE PROGRAMME

The Sensor Dry machine gives many options for drying the laundry to suit all circumstances. The table on the next page lists the programmes and the function of each programme.

Note:

The sensor may not detect a small load of small articles. For small loads and separate items or pre-dried fabrics with low moisture content, use the timed programmes.

If the sensor does not detect the item the dryer will only operate for 10 minutes before going into cooldown.

If the load is too large or too wet to tumble dry the dryer will automatically go into cooldown after approximately 3 hours.

In these cases we advise to use a time cycles between 30 and 75minutes depending on the load size and dryness required, and select high or low heat depending upon the fabric type.

EN 8

Image 8
Contents Instruction Book Index Safety Reminders IntroductionDelivery Information Unpacking the ProductSafety Reminders Installation Environmental IssuesGias Service LaundryInstallation Adjusting the FeetElectrical Requirements VentilationDrain Hose Fitting Instructions Never Preparing the LoadAlways Controls and Indicators Selecting the Programme Programme DescriptionWhen it is full Water Container Will Weigh about 6 kg Opening the DoorFilter Water ContainerCondenser OperationCleaning and Routine Maintenance OperationTroubleshooting Your Guarantee Hoovercare40007487