DRAIN HOSE : FITTING INSTRUCTIONS
To avoid emptying the water container after each drying cycle, the water can be discharged directly to a waste water drain pipe (the same drainage system as household sinks). Water
The kit consists of:1 hose and 1 tap.
WARNING! Switch off and remove the tumble dryer plug from the electricity supply before carrying out any work.
Fit the Hose as Follows:
1.Tilt the machine backwards.
2.Remove the bottom protector panel, by pulling carefully to the left side.
3.The waste water pipe is situated at the
4.Pull the hose off the bridge connection.
5.Attach the black hose from the kit,
(using the connector a n d p i p e c l i p s supplied), to the hose removed from the bridge connection.
6 . P l a c e t h e t a p supplied by the kit to close the remaing hose.
7.Feed the drain hose through the hole in the b o t t o m p r o t e c t o r panel.
8.Carefully slide the bottom protector panel back into position ensuring that the hose is not trapped.
9.Once the machine is in place the feet should be adjusted to ensure that the new hose does not kink when pushing the tumble dryer into position.
10.Connect the new drain hose to the waste Water pipe.
11.Connect to the m a i n s e l e c t r i c i t y supply.
EN 7