TROUBLESHOOTING
Iron won’t heat | * Is the iron plugged in and the outlet working? Check the |
| outlet by plugging in a lamp. |
| * Is the Thermostat Dial turned to a fabric setting? |
Water is leaking | * Do not overfill the water tank. |
out of the iron | * If steam ironing, is Steam Regulator in the steam position |
| and the Thermostat Dial in the steam range ? Did the iron |
| have enough time to preheat? |
| * If dry ironing, make sure the Steam Regulator is in the 0 |
| (no steam) position. |
| * If using burst steam, press button less frequently (not |
| more than once every two seconds. |
| * Follow the |
| tap water (not distilled) to “condition” the iron. |
Iron won’t steam | * Check the water level. |
| * Is the Steam Regulator in the STEAM position? |
| * Has the iron had enough time to preheat? |
Iron leaves spots | * ALWAYS empty the Water Reservoir of the iron after |
on clothing | using. Water left in the tank may discolor clothing and |
| soleplate. |
Wrinkles not | * Check Thermostat Dial is set to correct fabric. |
removed |
|
Fabric/Clothing | * Check Thermostat Dial and set to lower setting. |
scorched | * Allow iron to cool down 5 minutes before continuing. |
Twisted cord | * If iron cord should become twisted, turn iron off (o), turn |
| Thermostat Dial to MIN (o) and unplug iron. Let cool. |
| Empty water from iron. Hold iron cord in the middle of |
| entire length. Let plug and iron dangle freely until cord |
| uncoils. This will extend the life of your iron cord. |
11 | DA31066 / 31067 - 091112 |
Assembly page 11/16