DX9000 - USA 13.05.2003 15:04 Uhr Seite 1
Dry Ironing
To iron without steam, slide the steam control lever to the off position. We recommend dry ironing with an empty tank. Set the temperature for the type of material to be ironed.
Anti Calc System
Minerals in water can build up in the steam chamber. The Anti Calc system contains a special resin that neutralizes the harmful minerals. This system is designed to extend and maintain the high steam performance of the iron. The cartridge is not replaceable.
Note: Do not use descaling agents in your iron.
Anti-Drip System
In order to produce steam, all irons require a high temperature. If the soleplate is not hot enough some of the water will not turn to steam and can spit or leak from the soleplate. The
After Ironing
1.Turn the temperature dial to the min setting. Slide the steam lever to the no steam position.
2.Unplug the appliance.
3.Place the iron on its heel and allow to cool completely.
4.Empty water from the appliance before storing. We recommend emptying the iron when not in use.
5.To protect the soleplate, we recommend storing iron on its heel.
Cleaning and Maintenance
Before cleaning ensure that the appliance is unplugged and completely cooled down.
Never use household cleaners, abrasive cleaning pads or solvents.
Cleaning the Soleplate
Rowenta soleplates have excellent
•In normal use a draggy coating may build up on the soleplate (starch, detergent
•To prevent scratching of the soleplate, do not iron over sharp objects (zippers, etc.). Do not place the iron on rough surfaces, e.g. metal iron support, which may scratch the soleplate.
Troubleshooting
Issues | Possible causes | Solutions |
Iron does not | The temperature | Set the temperature control |
heat. | control is set too | to a higher temperature. |
| low. |
|
| Not properly | Check that iron is plugged in |
| plugged in. | correctly. |
| Move iron or shake it gently | |
| engaged. | to reactivate. |
LED Light Display | Temperature | Set the temperature control |
System does not | control is set to | to a higher setting. |
light up (depen- | minimum. |
|
ding on model). |
|
|
Not enough | There is insufficient | Fill the water tank. |
steam. | water in the tank. |
|
| Iron is not set to a | See section called "Steam |
| steam setting. | Ironing”. |
LED Light Display | Move iron or shake gently to | |
System is flas- | engaged. | reactivate. |
hing red – |
|
|
yellow – green |
|
|
(depending on |
|
|
model) |
|
|
Iron is emitting a | Water may need | See section "Water |
brown or white | to be changed due | Recommendations”. Switch |
substance. | to hardness or | to spring water or mix tap |
| organic matter. | water with distilled water. |
Brown streaks | Distilled or softe- | See section "Water |
come through | ned water being | Recommendations”. Switch |
the holes in the | used. | to spring water or mix tap |
soleplate. |
| water with distilled water. |
| Garment has not | Ensure garment is rinsed |
| been rinsed suffi- | thoroughly to remove any |
| ciently. | detergent deposits or chemi- |
|
| cals on new garments. |
Iron is leaking. | Over use of burst | Allow more time between |
| button. | each burst. |
| Distilled or softe- | See section "Water |
| ned water being | Recommendations”. Switch |
| used. | to spring water or mix tap |
|
| water with distilled water. |
| Overfilled. | Do not fill past max line on |
|
| tank. Be sure to close filling |
|
| inlet. |
Starch use. | Spray reverse side of fabric | |
soleplate. |
| and allow starch to penetrate. |
| Burnt material. | Be sure to set temperature |
| Ironing at too high | according to fabric being |
| a temperature. | ironed. |
Spray function | Priming may be | Hold cold iron horizontally. |
does not work. | necessary on first | Fill with water. Place finger |
| use. | over the spray nozzle to |
|
| create a vacuum. Press the |
|
| spray button 4 to 5 times. |
|
| Remove finger from nozzle, |
|
| press spray button a few |
|
| more times. |
If troubleshooting does not assist, before consulting the retailer regarding their return/exchange policy, please telephone consumer service at
In the interest of improving products, Rowenta reserves the right to change specifications without prior notice.
LIMITED WARRANTY
This Rowenta product is warranted against defects in material and workmanship for one year from the initial purchase date. During this period any Rowenta product owned by the original purchaser that, upon inspection by Rowenta, is proved defective, will be repaired or replaced, at Rowenta's option, without charge to the customer. If a replacement product is sent, it will carry the remaining warranty of the original product. This warranty does not apply to any defect arising from a buyer's or user's misuse of the product, negligence, failure to follow Rowenta's instructions, use on current or voltage other than stamped on the product or alteration or repair not authorized by Rowenta. Repair or disassembly by anyone other than a Rowenta authorized service center will void the warranty. THE WARRANTIES SET FORTH HEREIN ARE EXCLUSIVE AND NO OTHER WARRANTIES, EXPRESS OR IMPLIED, INCLUDING BUT NOT LIMITED TO ANY WARRANTY OF MERCHANTABILITY OR FITNESS FOR A PARTICU- LAR PURPOSE OR USE, ARE MADE BY ROWENTA OR ARE AUTHORIZED TO BE MADE WITH RESPECT TO THE PRODUCT. ROWENTA’S SOLE OBLIGATION IN THE EVENT OF A DEFECTIVE PRODUCT SHALL BE TO REPAIR OR REPLACE, IN ROWENTA’S SOLE DISCRETION, THE DEFECTIVE PRODUCT. IN NO EVENT SHALL ROWENTA BE LIABLE FOR ANY IN- DIRECT, SPECIAL, INCIDENTAL OR CONSEQUENTIAL LOSSES OR DAMAGES (INCLUDING BUT NOT LIMITED TO INTERRUPTION OF BUSINESS OR LOSS OF BUSINESS OR PROFIT) RESULTING FROM THE USE OF OR INABILITY TO USE THE PRODUCT, ANY BREACH OF WARRANTY OR ANY DEFECT IN THE PRODUCT EVEN IF ROWENTA SHALL HAVE BEEN ADVISED OF THE POSSIBILITY OF SUCH POTENTIAL LOSSES OR DAMAGES. If you believe your product is defective, bring the product (or send it, postage prepaid) along with proof of purchase to the nearest authorized Rowenta Service Center (see below). If you send the product, please include a letter explaining the nature of the claimed defect.
Rowenta Inc.
196 Boston Avenue Medford, MA 02155 Tel.:
OFFICE LOCATION ONLY.
To service product see service center information below.
If your appliance needs service, ship the product to your nearest regional service center. Be sure to put your name on the outside of shipping box (no P.O. boxes please). If in warranty, Rowenta will repair or replace product at their discretion. If the product is out of warranty, you will be advised of the cost of repair before any work begins.
Our main service centers are listed below:
Turnpike Appliance | Authorized Appliance |
|
|
|
3495A Lawson Blvd. | 1644 West Ogden Ave. |
|
|
|
Oceanside, NY 11572 | Downers Grove, IL 60515 |
|
|
|
|
|
| ||
Service center information is subject to change. Please visit |
|
|
| |
our website at www.rowentausa.com or call our service |
|
|
| |
center information line at |
|
|
| |
line provides current service center information and listings | Appliance description | |||
in California. |
| |||
| 1 | Thermostat light | 6 | Filling inlet (with |
|
| (mechanical model) |
| opening) |
|
| LED Light Display System | 7 | Spray nozzle |
|
| (electric model) | 8 | Cord |
| 2 | Spray button | ||
| 9 | Cord support | ||
| 3 | Power steam button | ||
| 10 | Water tank with maximum | ||
|
|
| ||
| 4 | Variable steam control |
| water level indicator |
| 5 | Temperature control dial | 11 | Soleplate (depending on model) |
Electronic
Rowenta Werke GmbH, 63016 Offenbach am Main | 7179 |
| 110 389 |