Rowenta DZ9030 manual Cleaning the iron, Problems?, Problems Cause Solution

Clean position (fig.5) : steam will now begin to build up. After a few seconds water will merge from the soleplate, rinsing dirt and scale particles out of the steam chamber. Move the steam control to position after approx. 1 minute. Plug in the iron and allow the iron to heat up again. Wait until the remaining water has evaporated. Unplug from the mains and allow the iron to fully cool down.

When cool, the soleplate can be wiped with a damp cloth.

TIP Use the Self Clean function approx. every 2 weeks. If the water is very hard, clean the iron weekly.

18 • Cleaning the iron

When the appliance has cooled down, wipe it down with a damp cloth or sponge, as required. Remove the dirt from the soleplate with a damp cloth or sponge.

IMPORTANT Do not use sharp or abrasive cleaning agents or objects to clean soleplate and other parts of the iron.

If the appliance has been standing unused for long periods, use the Self Clean function (see § 17).

PROBLEMS?

Problems	Cause	Solution
The iron is	No mains supply.	Check that the mains plug is properly
plugged in, but		inserted or try plugging the iron into
the soleplate of		a different socket.
the iron
remains cold.	Temperature control	Set the temperature control to a
	set too low.	higher temperature.
	The automatic	Move your iron.
	electronic cut-out*
	is active.
Thermostat	This is normal.	When the thermostat control light*
control light*		or the yellow led* goes on and off
or the yellow		the iron is heating up. As soon as the
led* goes on		thermostat control light* goes off or
and off.		the green led* lights up the set
		temperature has been reached.
Yellow and red	The electronic has	Contact an official Rowenta
LED are	an internal failure.	Customer service.
blinking
alternately.

* depending on model 9