RN40743 MUK Rev6:40715 rev3 27/03/2009 14:18 Page 5
FILLING A
1Make sure that the iron is not plugged in, then set the steam dial ‹ to ‘0’ position before filling the iron with water.
2Lift up the filler cap › and fill the water through the filling hole into the water tank „, using the beaker provided  A.
The tank holds 350ml of water. After filling, replace the filler cap.
IN HARD WATER AREAS, THE USE OF DISTILLED OR DEMINERALISED WATER IS RECOMMENDED.
WARNING: Never use battery topping up fluid or water containing any substances like starch, or sugar, or defrosted water from a refrigerator.
3Always pour out the remaining water after use.
WARNING: When filling your iron with tap water, always use the beaker provided. Never fill directly under the tap.
• Your Morphy Richards iron is | A |
|
| ||
fitted with a temperature |
|
|
indicator light ‚ which will go |
|
|
on and off whilst you are ironing. |
|
|
This is perfectly normal as it |
|
|
shows that the iron is |
|
|
maintaining the heat setting you |
|
|
have chosen. |
|
|
|
|
•It is always a good idea to begin with cool fabrics and work up to higher settings. An iron heats up quicker than it cools down so you will save time and energy.
FEATURES OF YOUR
IRON
Dry ironing
You can use your iron as a dry iron only. Make sure the variable steam control ‹ is set to the ‘0’ symbol.
Any temperature setting may be used depending on the garment. The spray feature may be used, provided there is water in the tank (see ‘Filling’ section). You do not need to put any water in the tank when dry ironing only.
TEMPERATURE
CONTROL B
B
1Plug in the iron and switch on. On certain models, the water tank „ will illuminate.
2Set the temperature control dial to the temperature required B, but don’t start ironing immediately. If you wait a few minutes, the iron will stabilise at the required setting.
Water Spray C
Press the spray button ⁄ and aim the spray of water at stubborn creases. You can do this whilst dry ironing providing there is water in the tank. When using the water spray it may be necessary to push the button a few times to get the spray pump primed.
C
⁄
|
|
|
For details of other Morphy Richards products, please see our website: | 5 |