Features of Your Iron

40513 rev1:RN40513 MUK Rev1 18/02/2009 11:16 Page 5

Temperature control B

Plug in the iron and switch on. Set the temperature control dial

‡to the temperature required B, but don’t start ironing immediately. If you wait a few minutes, the iron will stabilise at the required setting.

Your Morphy Richards iron is fitted with a temperature indicator light ‚ which will go on and off while you are ironing. This is perfectly normal as it shows that the iron is maintaining the heat setting you have chosen.

It is always a good idea to begin with ‘cool’ fabrics and work up to higher settings. An iron heats up quicker than it cools down so you’ll save time and electricity.

Temperature indicator light

Spray C

Press the spray button ¤ and

aim the spray of water at

stubborn creases. You can do

this whilst dry ironing, providing

there is water in the tank. When

using the water spray, it may be

necessary to push the button a

few times to get the spray pump

primed.

Variable steam

Fill the iron with water as

described in ‘Filling’, and insert

the plug into the electrical

socket.

The steam output can be varied

from low to high by rotating the

variable steam control D.

The steam facility should only be

used on garments which are

suitable for ironing at 2 and 3 dot

settings.

Shot of steam E

(certain models only)

The indicator light shows that the iron is warming up. When the required temperature is reached, the light will go out and will cycle on-off during operation.

Dry ironing

You can use your iron as a dry iron only. Make sure the variable steam control ‹ is set to the ‘0’ symbol.

Any temperature setting may be used depending on the garment. The spray feature may be used provided there is water in the tank (see ‘Filling’ section). You do not need to put any water in the tank when dry ironing only.

Press the shot of steam button

⁄to obtain a burst of extra steam for ironing out creases in

heavy material such as denim etc.

The shot of steam can be used whilst dry ironing, providing there is water in the tank, and the temperature control is set within E the steam range.

Do not use shot of steam at temperatures below the steam range shown on the control.

Note: For optimum steam quality, do not operate the shot more than three times in succession.

For details of other Morphy Richards products, please see our website:				5