Components of your iron, Filling | Morphy Richards Turbo steam iron

turbo steam RN40655 Rev 1 23/7/04 1:34 PM Page 4

Components of your iron

¤ ⁄
‹	„
	„
›	‚
	‚
ﬁ
ﬂ	·
‡	·
⁄ Shot of steam button
¤ Spray button	‰
‹ Variable steam control	‰

›Filling hole with cap ﬁ Spray nozzle

ﬂ Soleplate

‡ Illuminated temperature control dial · Water tank

‚ Life long anti-scale (certain models only) „ Power on indicator lights - Auto shut-off

indicator (certain models only) ‰ Filling beaker

Before use

Note: The steam facility should only be used on garments which are suitable for ironing at the 2 and 3 dot settings.

When ironing with the steam facility at the 2 dot setting, the steam output should be set at the lower end of the steam range (see variable steam section).

Textiles and clothes are supposed to carry ironing instructions. If they don’t you should follow the fabric guide on page 3, but be sure to test the temperature by ironing the hem of the garment or similar area first.

If you turn the control dial down from a hot setting to a cooler setting, wait until the iron temperature has stabilised before you continue ironing.

Filling

1Make sure that the iron is not plugged in and then set the variable steam control ‹ to the ‘0’ position before filling the iron with water.

2Open the fill cap and pour water through the filling hole › into the water tank ·, using the beaker provided, one beaker full of water fills the tank (400ml). A After filling replace the fill cap. In hard water areas the use of distilled or demineralised water is recommended.

Never use battery topping up fluid or

	water containing any substances like
	starch, or sugar, or defrosted water from a
	refrigerator.	A
	3 Always pour out the	A
	3 Always pour out the
	remaining water
	after use. Warning:
	When filling your
	iron with tap water
	always use the
	beaker provided.
	Never fill directly
	under the tap.

Temperature control

Plug in the iron and switch on. The ‘power on’ indicator lights „ situated in the back cover will illuminate. Set the temperature control dial B to the temperature required, but don’t start ironing immediately. If you wait a few minutes, the iron will stabilise at the required setting. Your Morphy Richards iron is fitted with an indicator light ‡ which will go on and off while you are ironing.