PROBLEM | POSSIBLE CAUSE |
WASHER IS NOISY ● Make sure washer is level and firm to the floor with rubber foot pads in place and
front jam nuts tight. See your Instdlatiort Instructions.
●A sharp, distinctive sound will be heard at the end of each spin period as the motor stops a’nd the spin brake inside the transmission “locks
. Heavily unbalanced loads can cause the washer to vibrate excessively during spin, and may cause it to move from its original position. In extreme cases (usually occurs when washing a single, heavy item or a small load when water level is set higher than necessary), the spin basket may strike the outer tub, creating a loud but harmless noise. To correct, stop the washer by pushing in the Cycle Selector knob, open the lid and redistribute the load evenly about the wash basket. Close the lid and restart.
WASHER PAUSES | I | ● Washer normally pauses between washing steps... such as between wash and spin or |
IN CYCLE | between spin and rinse. |
If you need more help...call, toll free: GE Answer Center@/ 800.626.2000/ consumer information service
CAW Am CLEAN~G
USER MAINTENANCE INSTRUCTIONS
The Tub. The porcelain is
The Exterior. Wipe off any spills of washing compounds. Wipe or dust with damp cloth. Try not to hit surface with sharp objects.
To Store Washer. Ask service technician to remove water from drain pump and hoses to prevent freezing.
Do not store the washer where it will be exposed to the weather.
For Long Vacations. Be sure water supply is shut off at faucets and drain all water from hoses if weather will be below freezing.
How to remove the agitator
To remove limestone from
To remove the agitator, snap the cap off and remove the screw.
Then remove the agitator extender (on models so equipped) and the agitator.
To replace the agitator, carefully lower it straight down onto the shaft so that it fits snugly into place. Replace the agitator extender (on models so equipped), the screw and the cap.
~— Cap Sciew
ii — Agitator
oExtender
(on some models)
— Agitator
h1;
) . .
,..
—Shafi
i
(Appearance may vary)
(on models so equipped)
●Soak filter pan in a preheated 160°F. (71 ‘C.) solution of half vinegar and half water for 15 minutes. Then brush each side of pan with a stiff bristle brush while flushing with running water.
CAUTIONS:
●Do not soak in porcelain container. Vinegar can damage porcelain.
c Do not exceed 180°F. (82°C. ) or filter pan may warp.
21