Surge of Steam
Use to remove stubborn creases.
1.With water tank filled to the MAX mark, turn the
2.To remove tough wrinkles, pump the 
button at
3.When finished ironing, turn the
the dry/steam selector to 
and unplug the iron.
Vertical Steam
Use for removing wrinkles from hanging clothes and drapes.
1.Hang the garment to be steamed on a clothes hanger (curtains or drapes can be steamed once they are hung).
2. Move the dry/steam selector to 
.
3. Hold the iron close to, but not touching, the fabric.
4. Pull the fabric tight in your free hand and pump the
button as you move the iron over the fabric (F).
5. When finished ironing, turn the
F
heat setting, move the dry/steam selector to 
and 
unplug the iron.
IRONING WITH SPRAY
Use to dampen tough wrinkles at any setting (G).
1. Be sure the iron is filled with water.
2. On first use, pump the 
button several times.
| DRY IRONING |
G | 1. Make sure dry/steam selector is set to . You may want |
to empty the water (see “Emptying Water Tank After | |
| Ironing - Optional”). |
2.Turn the
• The
• It then glows on and off during ironing.
3.When finished ironing, turn
4.Move the dry/steam selector to 
.
EMPTYING WATER TANK AFTER IRONING (OPTIONAL)
Note: It is not necessary to empty the water after each use.
1.Turn the
2.Unplug the iron and let it cool.
3.Open the
4. Empty the water by holding the iron over a sink with the tip pointing down. Water will empty out of
H
SPECIAL FEATURES
The
10-MINUTE AUTO SHUTOFF
1.If you leave the iron on its heel rest without moving it, the iron will automatically shut off after 10 minutes. The auto shutoff indicator light blinks to let you know that the iron has stopped heating. To turn it back on, move the iron until it starts heating again.
2.When finished, unplug the iron and stand it on its heel rest.
3.Move the dry/steam selector to 
.
Care and Cleaning
This product contains no user serviceable parts. Refer service to qualified service personnel.
CLEANING OUTSIDE SURFACES
1.Make sure iron is unplugged and has cooled completely.
2.Wipe the soleplate and outer surfaces with a soft cloth dampened with water and a mild household detergent. Never use abrasives,
3.After cleaning, plug in the iron.
4.Steam iron over an old cloth to remove any residue from the steam vents.
AUTO CLEANING
To keep the steam vents free of any buildup, follow these instructions about once a month.
1.Fill the tank with water well below the MAX line.
2.Plug in the iron.
3.Turn the
4.Turn
| 5. | Press and hold the AUTO CLEAN button. Be careful, as | |
|
| hot water and steam will come out of the steam vents (J). | |
|
| Continue to hold AUTO CLEAN button until all the water | |
|
| has emptied, or until you feel all mineral deposits have | |
|
| been flushed. If necessary, rock iron side to side and front | |
J |
| to back. | |
6. | When finished, release the button, stand the iron on its | ||
|
heel rest and plug it in. Heat for about 2 minutes to dry out any remaining water.
STORING YOUR IRON
1.Unplug the iron and allow it to cool.
2.Check that the dry/steam selector is set to 
.
3.Store vertically on its heel rest to prevent water leaking from the soleplate.
5 | 6 |