Vornado SF-510 warranty Connecting Pole TOP, Connecting Hanger, Adjusting Telescopic Pole

CONNECTING POLE TOP

1.Look at underside of Pole Top to locate two guide ridges (FIGURE 3-A).

2.Align Pole Top guide ridges with guide grooves on SECTION 1 of Telescopic Pole.

NOTE: It is recommended to orient Pole Top so Nozzle Cradle faces backwards towards rear of the unit.

3.Slide Pole Top onto SECTION 1 of Telescopic Pole (FIGURE 3-B). Press down firmly until Pole Top fits securely in place.

CONNECTING HANGER

1.Locate brackets on back of Hanger (FIGURE 4-A).

2.Align Hanger with Hanger Anchor Holes on front of Pole Top. Insert brackets into holes, then slide Hanger down to lock it in place (FIGURE 4-B).

4-B

4-A

FIGURE 4

ADJUSTING TELESCOPIC POLE

To adjust the length of SECTIONS 1, 2 & 3 of the Telescopic Pole:

1.Release extension lock directly below SECTION 1 by swinging hinge outward as shown. SECTION 1 can then be extended / retracted (FIGURE 5).

2.Once SECTION 1 is at desired length, close hinge to once again secure extension lock.

3.Repeat STEPS 1 & 2 for SECTIONS 2 & 3 of the Telescopic Pole, using the extension lock directly below each of those sections.

NOTE: It is recommended to extend Telescopic Pole to its full height during steamer operation; this will ensure optimal steam flow through the Hose.

3-A

3-B

FIGURE 3

FIGURE 5

ENGLISH 7