Operating Sequence
Before using your tumble dryer for the first time, we recommend you place a few damp cloths inside the appliance and dry for 20 minutes.
There may be dust inside a brand new tumble dryer.
Textile Button
Press the Textile button repeatedly, to select the desired option. The relevant light will light up. You can select 2 different options:
Cotton: to be used for cotton, .
Drying |
P1149 |
P1108 |
Synthetics to be used for synthetic or delicate items.
When the programme has finished the pilot lights End /Anticrease is on.
Start/Pause Button
Press this button to start the dryer after having selected the programme and the options. The relevant light will stop flashing. If the programme selector dial is turned to another position, when the machine is running, the buzzer will sound and the programme phase indicator lights will flash. The drum turns alternately in both directions during drying.
1. Load The Laundry
Connect the appliance. Open the door (see picture). Place the laundry in the drum, one item at a time, shaking them out as much as possible. Close the door. Please check the laundry does not get caught between the door and filter.
2. Select The Required Time.
Turn the programme selector dial to the required programme. The light Start/Pause starts to flash. Turn the dial to the required time.
The lights Drying, and End come on.
At the end of the programme the selector dial must be turned to position Off, to switch the machine off.
Attention!
If you turn the programme selector dial to another programme when the machine is working, the lights of the programme progress display start to flash. The machine will not perform the new selected programme.
3. Programme Option Buttons
Depending on the programme, different functions can be combined. These must be selected after choosing the desired programme and before depressing the Start/Pause button. When these buttons are pressed, the corresponding pilot lights come on. When they are pressed again, the pilot lights go out.
Delicate Button
Pressing this button allows drying to be performed at a lower temperature, for delicate items.
The corresponding pilot light comes on. .
DELICATE is only suitable for use with loads of up to 3kg!
When the programme has finished the pilot lights End is on.
All drying programmes end with a 10 minute cooling phase . You may remove the laundry after this phase. If the door of the appliance or the small door at the bottom is opened while the programme is running, this button must be pressed again after closing the door in order to restart the programme from the point at which it was interrupted. This button must be depressed also after a power failure and after having reinserted the water reservoir, if it has been emptied in the middle of a programme after lighting up of light “Empty Tank”.
In both cases the light of the “Start/Pause” button flashes to remind you that the start button needs to be pressed again.
4. Indicator lights
These lights indicate the following functions:
•Drying light - this light indicates that the appliance is in the drying phase.
•End / Anticrease light - this light is on at the end of the cooling phase, during the
•Empty Tank light - this light indicates that the appliance is in the drying phase. This light comes on at the end of the programme to remind you that the water reservoir must be emptied out. If this light illuminates during a programme this means that the water reservoir is full. The buzzer sounds, the programme stops, the light of the Start/Pause button flashes. This light comes on also when the water reservoir is not inserted correctly.
•Filter - this light illuminates at the end of the programme to remind you that the filters must be cleaned.
•Condenser- It comes on every 80 cycles to remind you that the condenser must be cleaned.
8