Unpacking
All transit bolts and packing must be removed before using the appliance
You are advised to keep all the packaging for
■Unscrew and remove the three rear transit bolts (using a spanner).
P0287 |
■Lay the machine gently on its back, making sure that the hoses are not squashed.
We suggest a polystyrene angle bracket from the packing is placed on the floor before tilting it back to avoid the hoses being squashed.
■Carefully remove the polyethylene bags located at the base of the machine by pulling them toward the centre of the machine.
■Plug the 3 holes with the plastic plugs which you can find in the envelope containing the instruction booklet.
P0002
Important !
You are advised to keep all the packaging for
In case of moving out the same precautions as per paragraph “The dangers of freezing” must be taken i.e. the residual water in the hoses must be pumped out.
Positioning
Install the machine on a flat hard floor.
Make sure that air circulation around the machine is not impeded by carpets, rugs etc. Check that the machine does not touch the wall or other kitchen units.
Never place cardboard, wood or similar materials under
P0018 |
1 2 |
AL009 |
the machine to compensate for any unevenness in the floor.
Your new washing machine has been designed to be permanently plumbed in to your home’s water supply and drainage system. However, if this is not possible, it may be connected to suitable existing tap with the drain hose discharging into a sink.
The appliance has one inlet hose, with female 3/4” BSP thread connector. If this connection is not compatible
■Place the machine in an upright position and remove the three plastic spacers.
P0001
with the plumbing of the existing installation, a variety of connectors are available from good hardware stores and plumbers merchants to suit most domestic plumbing. Any alteration to your existing plumbing must be carried out by a competent person, or qualified plumber.
Installation on a Suspended Floor
Suspended wooden floors are particularly susceptible to vibration. To help prevent vibration we recommend you place a waterproof wood panel, at least 15 mm thick under the appliance, secured to at least 2 floor beams with screws. If possible install the appliance in one of the corners of the room, where the floor is more stable.
23