Tricity Bendix BIW 102 installation instructions Electrical connections, Permanent connection

Page 30

Electrical connections

Any electrical work required to install this appliance should be carried out by a qualified electrician.or competent person

WARNING: THIS APPLIANCE MUST BE EARTHED.

The manufacturer declines any liability should this safety measure not be observed.

Before switching on, make sure the electricity supply voltage is the same as that indicated on the appliace rating plate (the plate is sticked to the rear of the appliance).

The appliance is supplied with a 13 amp plug fitted. In the event of having to change the fuse in the plug supplied, use a 13 Amp BS1362 fuse. Only ASTA or BSI approved fuses must be used.

Should the plug need to be replaced for any reason, proceed as described below.

The wires in the mains lead are coloured in accordance with the following code:

Green and Yellow

- Earth

Blue

- Neutral

Brown

- Live

Connect the green and yellow (earth) wire to the terminal in the plug which is marked with the letter «E»

or the earth symbol or coloured green and yellow.

Connect the blue (neutral) wire to the terminal in the plug which is marked with the letter «N» or coloured black.

Connect the brown (live) wire to the terminal in the plug which is marked with the letter «L» or coloured red.

The plug must not be used if the fuse cover/carrier is lost. The cover/carrier is indicated by the coloured insert at the base of the plug.

A replacement cover/carrier must be obtained from your local Bendix Service Centre, whose address are listed in this instruction manual.

WARNING: a cut off plug inserted into a 13 amp socket is a serious safety (shock) hazard.

Ensure that the cut off plug is disposed of safely.

GREEN & YELLOW

E

A13

L

N

BROWN

BLUE

P1041

CORD CLAMP

 

Permanent connection

In the case of permanent connection it is necessary that you install a double pole switch between the appliance and the electricity supply (mains), with a minimum gap of 3 mm between the switch contacts and of a type suitable for the required load in compliance with the current electrical regulations.

The switch must not break the yellow and green earth cable at any point.

30

Image 30
Contents BIW Page Installation Child SafetyDuring Use Contents Your New Washing Machine Ecological hintsInterest of the environment Description of the Appliance Detergent dispenser drawerMains-on light Control PanelDetergent dispenser drawer Half Load button Rinse Hold buttonMeasure out the detergent Operating SequenceLoad the laundry Add the fabric softener if requiredStart the machine At the end of the programmeDepress Rinse Hold button ,if required Start the machine Washing Hints 1000g = 1 kgWhich detergent to use? Using a water softening agent Which form?How much detergent and fabric softener? Wash Care Symbols Important NotesProgramme dial Description Washing ProgrammesWash programme MaxProgrammes for synthetics, delicates and wool SyntheticsMaintenance and Cleaning Cleaning the filter Water drain filterWater inlet filters Something Not Working Service & Spare Parts Symptom Possible causesCustomer care European guarantee Guarantee ConditionsBendix standard guarantee conditions This guarantee does not coverChannel Islands Midlands Installation Instructions Technical SpecificationsUnpacking Positioning Water inletWater drainage Levelling Special conditionsElectrical connections Permanent connectionEnsure that the cut off plug is disposed of safely Page Consumer care telephone number 08705 950