Instrucciones Para Operar Operating Instructions

INSTRUCCIONES PARA OPERAR (CONT.)

OPERATING INSTRUCTIONS

ALMACENAJE

1.Siempre gire el dial regulador de vapor a la posición “0” después de vaciar el agua de la plancha.

2.Permita que la plancha se enfríe.

3.Siempre guarde la plancha en posición vertical para proteger la suela de la plancha.

4.Limpie el exterior de la plancha ocasionalmente con un paño húmedo y séquela frotándola.

5.Si usa un spray de almidón para planchar, frote la suela de la plancha ocasionalmente con una tela suave húmeda para evitar la acumulación del almidón.

6.Si la plancha no se hubiese usado por varias semanas, sosténgala horizontalmente y permita que despida vapor por 2 minutos antes de planchar.

NOTA: La función antigoteo reduce el goteo de agua y sus las manchas; pero no si se presiona el botón para chorros súbitos de vapor con frecuencia, o si la temperatura de la plancha está demasiado baja. La cantidad del goteo de agua irá disminuyendo después utilizar la plancha para vaporizar dos o tres tanques completos de agua.

This appliance is for HOUSEHOLD USE ONLY and may be plugged into any 120V AC polarized electrical outlet. Do not use any other type of outlet.

FABRIC & TEMPERATURE INDICATORS

Press on the Electronic Temperature Control to select the desired fabric setting. The red lights at the left of the LED Display Panel will light up.

At the same time, the temperature indicator lights on the right side of the LED Display Panel will start to flash. They will stop flashing when the iron reaches the selected temperature.

DRY IRONING

For dry ironing, turn the variable steam control dial all the way to the right to “0”. This will cut off the steam flow if water is in the water tank. All marked fabric settings on the LED Display Panel can be used for dry ironing.

1.Plug the cord into a polarized, 120V AC electrical outlet. The power “ON” light will come on, indicating that the iron is receiving power.

2.Press on the electronic temperature control button to select the desired fabric/temperature setting. Turn the variable steam control dial to “0”. (See “Ironing Guide” for a guide to temperature selection.)

3.Place iron on its heel (on a stable, protected surface) while iron is warming to desired temperature.

STEAM IRONING

CAUTION! DO NOT aim iron at face, towards yourself, or anyone else while using or adjusting steam. Burns or serious injury may occur.

WARNING! Before filling the iron with water, be sure the iron is not plugged into the electrical outlet. The iron may be filled with water while it is hot.

CAUTION! TO PREVENT THE RISK OF BURNS, use caution when filling iron with water. Burns can occur from touching hot metal parts, hot water, or steam.

NOTE: Because of the soleplate design, ordinary tap water may be used with this iron. However, in very hard water areas, we recommend using distilled or demineralized water.

WARNING: Never fill the iron with fabric conditioner, starches or any other liquid, as these will damage the steam mechanism. Do not use contaminated water.

1.Open the water filling inlet cover. Holding the iron at a slight angle, pour water slowly into the water filling inlet. See figure 1. Fill tank to desired level or to the “MAX” water level marking using the water filling flask. (When the iron is upright, the see-through water tank allows you to gauge the amount of water.) DO NOT overfill the tank. When finished filling the iron with water, close the water inlet cover before continuing.

Fig. 1

2.Plug the cord into a polarized, 120V AC electrical outlet.

3.Press on the electronic temperature control button to select the desired fabric and temperature setting. Turn the variable steam control dial to the desired steam setting. (See “Ironing Guide” for a guide to temperature selection.)