Electrical Instructions, Water Instructions

ELECTRICAL INSTRUCTIONS

To avoid a circuit overload, do not operate another high-wattage appliance on the same circuit simultaneously with the steam iron.

If an extension cord is necessary, a 15-amp rated cord with a polarized plug should be used. Cords rated for less may overheat and cause damage.

Polarized Plug: This steam iron system uses a polarized plug (one blade is wider than the other). As a safety feature, this plug will fit into a polarized outlet only one way. If the plug does not fit fully into the power outlet, reverse the plug. If it still does not fit, contact a qualified electrician. Do not attempt to defeat this safety feature.

WATER INSTRUCTIONS

Your steam iron system has been planned for use with normal tap water. In order to extend the life of this product, if where you are living the level of water hardness is very high, we recommend to use 50% of normal water with 50% of demineralised or distilled water. Do not use softened water or bottled water.

Instructions To Programme The Anti-Calc Feature

To set the de-scaling programme, you have to identify the water hardness in your area through the water tester supplied with the ironing station.

Proceed as follows:

a. Immerse the litmus paper into a water glass for one second b. Take out the litmus paper and shake it in order to dry it,

c. Wait one minute and refer to the scale here below,

d. The number of red squares show the water hardness, e. The litmus paper can be used only one time

			 Soft water
			 Medium hard water
			 Hard water

   Very hard water Diagram (A)

•For soft and medium hard water, it is okay to use regular untreated tap water.

•For hard water and very hard water, it is recommended that you use a combination of tap and distilled water.

The de-scaling programmer is arranged as follows:

Diagram (B)

Red L.E.D. indicates the hardness of the water.