Drain Hose Installation Instruction (The drain hose is installed inside the bottom of the base.)
1.Lay down the washing machine with the back body facing to the upside.
2.Peel off the tape and pull out the drain hose from the base.
Rear
|
| Base |
Drain Hose |
|
|
Tape |
|
|
Front | Drain Hose | Pull out. |
| ||
Spread a mat such as cardboard under the body to avoid scratches. |
| |
|
|
7 To change the drain hose to opposite.
1.Lay down the washing machine with the back body facing to the upside.
2.Remove the screw fixing the hose holder.
Hose Holder
Screw
3. Remove the hose holder from the base.
Caution
Make sure the hose holder is fixed on the base properly to avoid water leaking caused of the hose damaged.
Note
Make sure to remount the bottom cover after pulling out the drain hose or changing its position.
(Ex. Changing hose position from right to left.)
4.Move the hose holder to opposite side. Then insert the hose holder to left hose outlet position of the base.
For
For
Note
Do not remove the hose holder from the drain hose.
5. Fix the hose holder with screw properly.
Note
Make sure the drain hose is not twisted.
Bottom Cover Installation Instruction
A.Purpose
For safety precaution.
B.How to install Bottom Cover to the Base
1.Lay down the washing machine with the back body facing to the upside.
2.Adjust the Hose Hole Cover A (accessory) to the slot at the base.
3.Fix Bottom Cover (accessory) where surface with UP indication is facing to the washing machine. Then securely fasten the 9 screws of the Bottom Cover to the Base.
Hose Hole Cover A
Bottom Cover
18
5/8/08 9:16:47 AM |