Special Instructions

•Your SUNBEAM@ Iron is designed to rest on the heel rest. Do not leave the iron unattended. Do not set the iron on an unprotected surface, even if it is on its heel rest.

•

This is a 400 watt appliance.. To avoid a circuit overload, do not operate another high wattage appliance on the same circuit.

If an extension cord is absolutely necessary,

a lo-ampere cord should be used. Cords rated for less amperage may overheat. Care should be taken to arrange the cord so that it cannot be pulled or tripped over.

•This appliance was set at the factory to operate at 120 Volts. Refer to Operating Instructions Section of this manual for conversion to 240 Volt operation.

•Be sure dual voltage selector is in the correct voltage position before operation. Before plugging iron into outlet, read the information about dual voltage operation in the “Voltage” section of this manual.

•To reduce the risk of electrical shock, this appliance has a polarized plug (one blade is wider than the other). This plug fits a polarized outlet only one way; if the plug does not fit fully into the outlet, reverse the plug. If it still does not fit, contact a qualified electrician. Do not attempt to defeat this safety feature.

SAVE THESE INSTRUCTIONS *