Unpacking
When unpacking your 20 Gallon Parts Washer, check to make sure that all parts listed in the parts list on page 10 are included. If any parts are missing or broken, please call HARBOR FREIGHT TOOLS at
Assembly
Your Parts Washer will require complete assembly before use. It is important that you read the entire manual to become familiar with the product BEFORE you set up and use the Parts Washer.
1.Set the Body (7) upside down onto your work surface. Be careful to avoid breaking or scratching the Cover (1).
2.Attach each of the four Legs (13) to the Shelf (12). Secure Legs (13) to the Shelf (12) with two Pan Screws (14), two Washers (8), and two Nuts (9) through each Leg (13) and into the Shelf
Figure 1- Legs to Shelf | Figure |
Body (7)
Pan Screw (14),
Washer (8),
Nut (9)
Pan Screw (14),
Washer (8),
Nut (9)
Leg (13) | Shelf (12) |
3.Attach Legs (13) with Shelf (12) to the Body (7). Secure to the Body (7) with four Pan Screws (14), four Washers (8) and four Nuts
4.Stand the Parts Washer on its Legs (13). Secure the Switch Box (21) in place on Pump Housing (18) with four Screws (22). Attach the Pump Housing (18) to the Body (7) by setting it into the hole located on the side and secure in place with Nuts (31) and Washers (32).
5.Insert the Filter Screen (17) into the Filter Cover (16 ). Slide the Pump Housing Cover (15) down into the slots on the front of the Pump Housing (18).
Operation
Warning: Do not use any highly volatile, flammable or combustible solvents, or fuels such as gasoline, diesel, or toluene. Use only
Warning: Parts being cleaned may contain and leave flammable or combustible residue or fluids in the Parts Washer. Check for solvent fumes to verify nonflammability and
solvents properly.
The pump must be immersed in liquid while operating. Fluid should be replaced and the Parts Washer cleaned on a regular basis to avoid hazardous conditions.
SKU 94702 | For technical questions please call | Page 8 |