AEG W 1020 manual Excessive foaming

Operating instructions

Malfunction	Possible Cause	Remedy
Excessive foaming	Probably too much detergent	Dose detergent exactly in
		accordance with the manu-
during the main wash.	was used	facturer’s instructions.
	Threaded fitting on the	Tighten the water inlet hose
	water inlet hose is leaking.
	Drain hose is leaking.	Check drain hose and if
Water runs out from		necessary replace.
under the washing	Circulation pump cover is	Close cover properly.
machine.
	not closed properly.
	Washing is trapped in the	Stop program, remove
		washing from the door, start
	door.
		a new program.
Softener is not washed	Suction cap in the compart-	Clean detergent drawer,
in, compartment w	ment for conditioner is not
		place suction cap firmly in
for conditioner is full	correctly positioned or is blo-
of water.	cked.	position.
Appliance does not	o (RINSE HOLD) selected.	Deselect o (RINSE HOLD).
spin, water in the
drum.
	Drain hose is kinked.	Remove kink.
	Maximum pumping height	Please contact customer ser-
	(drain height 1m above the	vice who have a retrofit kit
Washing is not spun	floor on which the machine	for pumping to heights of
	is standing) exceeded.	greater than 1m.
properly, water is still		Switch off the machine and
visible in the drum.	Circulation pump is blocked.
		unplug from the mains, clean
		the circulation pump.
	In the case of siphon con-	Clean siphon.
	nection: siphon is blocked.
It is not possible to	The door is locked for safety	Wait 1-2 minutes after the
open the door.	reasons.	end of the program.
	This is probably due to using	No negative impact on the
Rinse water is cloudy.	a detergent with a high sili-	rinsing results, try using
	cate content.	liquid detergent.

26