Technics SL-PD947 Concerning the Remote Control, Battery installation, Use of batteries

Page 5

Concerning the Remote Control

Battery installation

fl

Openthe ]

f/'_ Insertthe I

ft'_ Cl°sethe]

Open the cover,

Be sure that you insert the batteries so that their positive (+)

and negative

(-)

polarities

match the polarities indicated in

Press gently and slide the cover out.

the compartment.

Batteries

installed with incorrect polarities

 

 

may leak and damage.

 

2 Insert the

batteries Included with this unit.

Refer to "Use

of batteries"

for additional information.

IEC R03 (1.5

V) or equivalent batteries.

3 c,o,ethe

cover.

 

When you need to replace these batteries, use two UM-4 AAA,

 

 

 

 

Use of batteries

Do not try to mix old and new batteries or batteries of different types (carbon and alkaline, etc.).

Always remove old, weak or worn-out batteries promptly and dispose of them properly.

The average battery life is about one year. Although the battery life varies depending on how often the device is used, you should generally replace the batteries about once a year.

Replace the batteries if commands from the remote control transmitter do not operate the unit even when the transmitter is held close to the front panel.

Never subject batteries to excessive heat or flame; do not attempt to disassemble them; and be sure they are not short-circuited.

If you will not use the remote control for a long period of time, remove the batteries and store them in a cool, dark place.

If a battery leaks, remove all batteries and dispose of them proper- ly. Thoroughly clean the battery compartment before inserting new batteries. If the leaking electrolyte comes into contact with skin or clothes, flush with water immediately.

Keep batteries out of reach of children.

Do not use rechargeable type (nickel-cadmium) batteries.

Do not attempt to recharge alkaline or carbon batteries.

Operation notes

B

(_) Aim the remote control transmission window toward the changer's sensor. Avoid any obstacles.

(_) Use the remote control within a 60-degree angle of the

changer.

The reachable distance is within 7 meters (23 ft.) directly facing

toward the changer.

_Avoidd

(_) Be sure the transmission window and the changer's sensor are free from dust. Excessive dust might prevent reception.

If direct sunlight or other strong light sources strike the remote con- trol signal sensor of the changer, operation may be impaired. If there is a problem, place the changer away from the light source.

5

Image 5
Contents Completely Operating InstructionsTable of Contents Safety PrecautionsInstallation MaintenancePreparations Supplied accessoriesR3conn.c,,he TransmitterBattery installation Concerning the Remote ControlUse of batteries Openthe Insertthe Ft Clsethe Open the coverControl section Front Panel Controls and FunctionsProgram mode button Program Mode Random mode button Random ModeAuto cue button Auto CUE Spiral button SpiralDisplay section On the disc Load the discs Trays Basic Operating ProcedureLoad the discs on the disc trays Press Openiclose again to close the loading drawerTo exchange discs during play Sequential PlayPress the play button SECllTo temporarily stop play A,o.v.,ebfromtheremote.control When listening through headphonesFrom the main unit Direct Access PlayPress the desired disc button 1 Press the numeric buttons to select the trackPress the numeric button 1 -5 to select the disc From the remote controlFlashes Track numberPress the desired disc button Program PlayPress the numeric buttons to specify the track number Press Play to start playTo clear the entire programmed contents without canceling Press the numeric button 1 -5 to specify the disc number Program Play ,oonPress To confirm the program Each Time you press CLEAR, you Will cancel last Entry OrderTo clear a program entry Press RecallDelete Play Delete play indicatorPress the disc button Press to start playPress Stop during play Press Program Mode To cancel delete mode AaoavailablefromtheremotecontrolPress Stop in the delete mode Start the desired play except program play4 as Desiredepeat. steps 2 Delete Play ,on,,nu13E4 Skip to if you want to enter only the disc numberPress Clear To confirm the selections to be deletedTo clear a selection to be deleted One disc random play Also availablefromtheremotecontrol To cancel one disc random play modeRandom Play 17-1-t FuII ra ndo m pIay .,...,,.,.,.om,,.remote controlTo cancel full random play mode Which is playing To cancel spiral play modeSpiral Play To cancel ID scan Special FeaturesWhen the desired track has been found Press Play Press ID ScanTo play Standard pitch Special Features ,o,,nPitch control function Auto cue function To cancel auto cuePress Auto CUE Press Play again to start playTo cancel repeat function Special Features ,.o,,u.oPress Repeat before or during play Press Repeat againPress Disc Skip to rotate the disc tray To skip tracksTotal remaining time on the disc CO edit.recording modeAbout sequential-edit-recording CD Edit-RecordingAbout program-edit-recording See pagesSequential-edit-recording CD Edit-Recording ,co.,,.uIf a cassette deck to be used has no synchro edit To stop recording711function Prog ra rn.edit.re cord ing CD Edit-Recording ,oo.,,.uoJ, PGM2 . . . . .4 EDffll. o= I 31p45Remove Press Power to switch off the powerBefore Moving Random play Quick Reference Table of Remote Control OperationSequential/direct access play Select Program or Olsc DISC2 DISC3DISC4DISC5 Delete Mode Special featuresProgramldelete play Ooooo4Handling precautions Technical SpecificationsStorage precautions Concerning Compact DiscsProduct Service Troubleshooting GuideProblem Probable causes Product informationIndex

SL-PD947 specifications

The Technics SL-PD947 is a high-end multi-disc CD player that represents the pinnacle of audio engineering from the renowned brand Technics, a subsidiary of Panasonic. Launched in the late 1990s, this player was designed to provide exceptional sound quality and user experience, setting a standard for CD players of the era.

One of the standout features of the SL-PD947 is its ability to hold up to five discs in a carousel format, allowing for uninterrupted listening. This feature caters to the audiophile who desires a seamless listening experience without the hassle of changing discs frequently. The intelligent programming of tracks enables users to create custom playlists without manual intervention.

The SL-PD947 employs advanced digital audio technologies to enhance sound quality. The built-in 20-bit digital-to-analog converter (DAC) is pivotal in delivering clear, high-resolution audio reproduction. This results in a richer, more detailed sound profile, bringing out nuances in the music that are often lost in lesser players. Additionally, Technics integrated their proprietary "High-Precision Digital Filter" technology, which reduces digital distortion, ensuring that the audio remains true to the original recording.

Another significant characteristic is its robust build quality. The SL-PD947 features a solid chassis design that minimizes vibration, ensuring that the audio signal remains pure and undistorted. The front-loading design also allows for easy access to discs, making it convenient for users.

The player supports CD-R and CD-RW formats, expanding its versatility and allowing users to play custom mixes and recordings. Moreover, its extensive compatibility with various disc formats makes it a flexible choice for those with diverse music collections.

User-friendly features like track programming, repeat functions, and shuffle play are also prominent in the SL-PD947, enhancing the overall user experience. The intuitive interface and remote control functionality make it easy to operate, whether from a distance or up close.

In summary, the Technics SL-PD947 stands out for its impressive multi-disc capacity, high-quality audio technology, solid construction, and user-friendly features. As a testament to Technics’ commitment to high-fidelity audio, this CD player remains a cherished component in the audio setups of many music enthusiasts and collectors.