GB
5.11STARTING THE WASHING PROGRAMME
1.Before starting the selected programme, carefully close the door, open the water tap and add the detergent and additive
2.Press the
cycle.
After starting, the display shows the time remaining until the end of the programme. The LED remains on throughout the cycle.
Example
If delayed starting has been set (only for models featuring this option), the display visualises the time remaining before the cycle starts. When delayed starting is set, the relative LED flashes on and off.
Example
5.12 INTERRUPTING OR CHANGING THE WASHING PROGRAMME
The washing programme may be interrupted at any time while it is running:
1.press “Start/Pause” for approximately 3 seconds: the display alternates between STOP (for 1 second) and three horizontal lines (for 1 second) and the Start/Pause LED flashes.
The programme can also be stopped by turning the programme/temperature selection knob while the cycle is running.
2.If you wish to change the washing programme, simply select the new programme by turning the programme knob without pausing the machine first. The new washing cycle will be performed starting from the beginning. If the tub is already full of water, the new programme will omit the filling phase.
3.To resume the cycle, press
5.13END OF PROGRAMME
The washing programmes are automatically completed, the display shows END and the “Time remaining” LED lights up.
1.Turn the programmes knob to OFF to switch off the machine.
2.Open the door.
3.Remove the washing from the drum.
4.Leave the door ajar in order to allow the inside of the washer dryer to dry.
5.Turn off the water tap.
If the
17