5Maintenance and cleaning
Fluff filter
Lint and fibres released from the laundry to the air during the drying cycle are collected in the “Fluff Filter”.
CSuch fibre and lint are generally formed during wearing and washing. Always clean the filter after each Drying process. You can clean the filter and filter area by vacuum cleaner.
For filter cleaning; Open the cover. Remove the fluff filter by pulling it up and open the filter.
Clean lint, fibre, and the fluff by hand or with a soft piece of cloth. Close the filter and place it back into its seat.
Sensor (models equipped with a sensor)
There are humidity sensors in your machine that detect whether the laundry is dry or not.
For sensor cleaning; Open the
door of the machine. Allow the machine to cool off if drying has
been carried out. Wipe the metal sensors with a soft cloth, dampened with vinegar and dry them.
CClean metal sensors 4 times a year.
A Never use solvents, cleaning agents or substances alike when cleaning as these might cause fire and explosion!
Water tank
The moisture in the damp laundry is taken from the laundry and condensed. Drain the water tank after each drying cycle or during drying when “Water tank” warning LED comes on.
ACondensed water is not drinkable!
A Never take out the water tank when the program is running!
Water tank may be located in two different places, namely, inside the drawer on the panel or inside the kick plate cover.
If you forget to drain the water tank, your machine will stop during the following drying cycles when the water tank is full and the “Water tank” warning LED will light on. If this is the case, press the “Start/Pause/Cancel” button to resume the drying cycle after draining the water
tank.
To drain the water tank; Carefully remove the water tank by opening the kick plate cover/ pulling the drawer.
1Drain the water by opening the water tank cover.
2If there is lint accumulation in the water tank cover, clean it and press to close.
3 Place the water tank into its seat.
Condenser
Hot and humid air in the condenser is cooled with the cold air from the room. Thus, the humid air circulating in your machine is condensed and then pumped into the tank.
CClean the condenser after every 20 drying cycles or once a month.
To clean the condenser; If a drying process has been carried out, open the door of the machine and wait until it cools down. Unlock the 4 condenser locks after opening the kick plate. Pull out the condenser. Clean the condenser with pressurized water and wait until the water drains.Replace the condenser with the side labeled “Top” facing upwards. Lock the 4 condenser locks. Make sure that the red lock on the upper right corner is engaged securely.
Close the kick plate cover.
Close properly and check the locking latchs?
11 - EN