extended directly to the outdoors. There must be a small number of elbows as not to hinder air ventilation.
CThe ventilation hose can be routed outdoors via a window or it can be connected to the air outlet in the bathroom.
CTo prevent water accumulation in the hose, make sure that it is not folded on the floor.
BThe air ventilation hose should not be connected to the chimney of a stove or a fireplace.
BPay attention that the air inlet openings are unobstructed.
BDo not operate your machine at the same time with heaters such as a coal or gas stove. Airflow may cause the chimney to flare up. Airflow may cause the chimney to flame up.
Connection to a water drain (for products equipped with a condenser)
In products equipped with a condenser unit the water accumulated during the drying cycle is collected in the water tank. You should drain the accumulated water after each washing cycle. You can directly send the accumulated water out through the water drain hose supplied with the machine instead of periodically draining the water collected in the water tank.
Remove the hose on the machine by pulling it out from its end in order to make the water drain hose connection. Do not use any tools to take out the hose. Attach the drain hose adaptor to the end of this hose. Connect the special drain hose supplied with the machine to the hose adaptor fitting. The other end of the drain hose can be directly connected to the wastewater drain or to the washbasin. The fitting must always be secured in all types of connections.
CWhen you direct the water drain out, “Water Tank” warning LED will light up at the end of each program.
•The hose should be attached to a height of maximum 80 cm.
•You must be careful not the pinch or bend the hose.
Electrical connection
Connect the machine to an earthed outlet protected by a fuse of suitable capacity. Important:
• Connection should comply with national regulations.
• Power cord plug must be within easy reach after installation.
• The voltage and the allowed fuse protection are specified in the section “Technical Specifications”.
• The stated voltage must match with your mains voltage.
• Connection via extension cords or
• The main fuse and switches must have a contact distance of minimum 3 mm.
BA damaged power cable must be replaced by a qualified electrician.
BThe appliance must not be operated unless it is repaired! There is the risk of electric shock!
Disposal
Packaging material can be dangerous to children. Keep the packaging materials out of the reach of children or dispose of them accordingly. Do not dispose them together with normal domestic wastes.
Disposing of the old machine
Dispose of your old appliance in an environmental friendly manner.
•You may refer to your local agent or solid waste collection center in your municipality to learn how to dispose of your machine.
Before disposing of your old machine, cut off the mains plug and make the door lock unusable, so children will not be endangered.
4 - EN