C The end of the hose should never be higher than the level of the water outlet on the machine. Otherwise, the “tank full” light of your machine will illuminate and stop the programme.
C If the dryer is mounted on the washing machine by means of a bracket, use of the water drain hose is recommended. The drain hose should be directed downwards as shown in the figure.
Adjusting feet
In order to ensure that your product operates more silently and vibration- free, it must stand level and balanced on its feet. Front feet of your product can be adjusted. Balance the machine by adjusting the feet.
1.Loosen the feet by hand.
2.Adjust the feet until the product stands
level and firmly on the floor.
CDo not use any tools to loosen the adjustable feet, otherwise, they can be damaged.
CNever remove the adjustable feet from their housings.
2 plastic pieces supplied along with the user manual prevent your machine from slipping on wet and slippery surfaces. To install the plastic parts:
1.Tilt your product to backwards.
2.Fit the plastic parts on to the front adjustable feet. Press on the plastic parts to snap them into their seating.
3.Check the balance of your product again and readjust the adjustable feet if necessary.
Electrical connection
Connect the machine to a grounded outlet protected by a fuse of suitable capacity as stated in the technical specifications table. Our company shall not be liable for any damages that will arise when the machine is used on a circuit without grounding.
• Connection must comply with national regulations.
• If the current value of the fuse or breaker in the house is less than 16 Amps, have a qualified electrician install a 16 Amp fuse.
• Power cable plug must be within easy reach after installation.
• The voltage and allowed fuse or breaker protection are specified in the “Technical Specifications” section.
• The specified voltage must be equal to your mains voltage.
• Do not make connections via extension cables or
• The main fuse and switches must have a contact distance of minimum 3 mm.
BDamaged power cable must only be replaced by a qualified electrician.
BIf the product is faulty, it must not be operated unless it is repaired! There is the risk of electric shock!
First use
•To have the product ready for operation before calling the authorised service agent, make sure that its location
and power supply installations are appropriate. If they are not, call a qualified electrician to have any necessary arrangements carried out.
•Make sure that the power connections of the product are in accordance with the instructions given in relevant chapters of this manual.
Disposing of packaging mate- rial
Packaging materials are dangerous to children. Keep packaging materials in a safe place out of reach of children.
Packaging materials of your product are manufactured from recyclable materials. Sort and dispose of them in accordance with recycled waste instructions. Do not dispose of them with normal domestic waste.
7 - EN