Smeg S600TL manual Before contacting After-Sales Service, Specify

Page 14

6GB10055.fm Page 14 Monday, August 2, 2004 12:33 PM

AFTER-SALES SERVICE

Before contacting After-Sales Service:

1.Try to remedy the problem yourself (see “Troubleshooting Guide”).

2.Restart the programme to check whether the problem has solved itself.

3.If the machine continues to function incorrectly, call After-Sales Service.

Specify:

•The nature of the problem.

•The exact model of the washing machine.

•The service code (number after the word SERVICE).

The After-Sales Service sticker is in the lid of the foreign body trap or on the rear of the machine.

• Your full address.

• Your telephone number and area code.

As a priority, you should contact the After-Sales Service of the retailer who supplied you with the washing machine.

TRANSPORT AND HANDLING

1.Unplug the washing machine.

2.Turn off the tap.

3.Remove the water supply and drain hose.

4.Eliminate all water from the hoses and the washing machine (see “Draining residual water”).

Wait for the water to cool so as to avoid any accidents.

5.To facilitate moving the machine, pull the handle situated at the bottom front (optional on certain models) out a little by hand and pull it out to the stop with the foot.

Afterwards push the handle back into the original stable position.

6.Fix the transport bracket again for transportation.

7.Transport the washing machine upright.

IMPORTANT: Do not use the washing machine while the handle is pulled out.

GB 14

Page 13 Page 15
Image 14
Page 13 Page 15
Contents Contents Remove the packaging and check Electrical connection Before Using the Washing MachineInstall the washing machine Remove the transport bracketPrecautions and General Recommendations First Wash CycleSort the laundry Description of the Washing MachinePreparation of the Washing Starching Stain removalDyeing and bleaching Loading the laundry Open the machine lidFilling up with detergents and additives Detergents and AdditivesDosage Choice of the right detergents and additivesProgramme Selection Cleaning the Foreign Body Trap Draining Residual Water Detergent dispenserWater inlet hose filter Plug the washing machine backWashing machine does not start, but the pilot lamp is on Water inlet hosesWashing machine does not start, no lamp lights up Washing machine stops during the programmePump operates Water stop fault depending on modelWater Stop fault may have been triggered by Wait for the water to cool so as to avoid any accidents Before contacting After-Sales ServiceSpecify Removal of transport bracket Adjust the feet Connect the water inlet hoseWater stop anti-flooding system Connect the water drain hoseTo fit a new plug, proceed as follows Fuse replacementValid Only For Great Britain And Ireland Polarized Plugs e.g pin, 13 amp plug conforming to BS 1363AGB S 600 TL MaxNo Spin button Rinse Hold buttonAppliance in Rinse Hold Half Load button
Top Page Image Contents