Smeg S600TL manual Cleaning the Foreign Body Trap

Page 9

6GB10055.fm Page 9 Monday, August 2, 2004 12:33 PM

CLEANING THE FOREIGN BODY TRAP

The washing machine is provided with a self-cleaning pump. The foreign body trap keeps objects like buttons, coins, safety-pins etc. which have been left in the laundry.

1.Unplug the washing machine.

2.Open the foreign body trap cover with a coin.

3.Place a bowl beneath it.

4.Turn the foreign body trap slowly anti-clockwise until the grip is vertical; do not remove it as yet.

5.Wait until all the water has drained out.

6.Now unscrew the foreign body trap completely and extract it.

7.Remove any foreign items from the foreign body trap.

8.Make sure the pump impeller (in the housing behind the foreign body trap) is not obstructed.

9.Insert the foreign body trap again and screw it fully down in a clockwise direction to the stop (until the grip is horizontal).

10.Pour 0.5 litres of water into the machine via the drum and check that water does not leak from the foreign body trap.

11.Close the foreign body trap cover.

12.Reconnect the washing machine.

Check the foreign body trap if the washing machine is not draining correctly or if it fails to perform spin cycles.

The machine has safety device which stops the washing machine before each filling when water was not removed completely from the tub in previous part of washing programme.

Check the foreign body trap regularly, two or three times a year and clean it if necessary.

IMPORTANT: Make sure the water has cooled before emptying the foreign body trap.

GB 9

Page 8 Page 10
Image 9
Page 8 Page 10
Contents Contents Install the washing machine Before Using the Washing MachineRemove the packaging and check Electrical connection Remove the transport bracketFirst Wash Cycle Precautions and General RecommendationsDescription of the Washing Machine Preparation of the WashingSort the laundry Stain removal Dyeing and bleachingStarching Open the machine lid Loading the laundryDosage Detergents and AdditivesFilling up with detergents and additives Choice of the right detergents and additivesProgramme Selection Cleaning the Foreign Body Trap Detergent dispenser Draining Residual WaterPlug the washing machine back Water inlet hose filterWashing machine does not start, no lamp lights up Water inlet hosesWashing machine does not start, but the pilot lamp is on Washing machine stops during the programmeWater stop fault depending on model Water Stop fault may have been triggered byPump operates Before contacting After-Sales Service SpecifyWait for the water to cool so as to avoid any accidents Removal of transport bracket Connect the water inlet hose Adjust the feetConnect the water drain hose Water stop anti-flooding systemValid Only For Great Britain And Ireland Fuse replacementTo fit a new plug, proceed as follows Polarized Plugs e.g pin, 13 amp plug conforming to BS 1363AMax GB S 600 TLAppliance in Rinse Hold Rinse Hold buttonNo Spin button Half Load button
Top Page Image Contents