Smeg S800TL1 manual Contents

Page 1

BEFORE USING THE WASHING MACHINE FIRST WASH CYCLE

PRECAUTIONS AND GENERAL

RECOMMENDATIONS

DESCRIPTION OF THE WASHING MACHINE PREPARATION OF THE WASHING DETERGENTS AND ADDITIVES PROGRAMME SELECTION

CLEANING THE FOREIGN BODY TRAP DRAINING RESIDUAL WATER

CARE AND MAINTENANCE

TROUBLESHOOTING GUIDE

AFTER-SALES SERVICE

TRANSPORT AND HANDLING

INSTALLATION

ELECTRICAL CONNECTION

Image 1

Contents Contents Install the washing machine Before Using the Washing MachineRemove the packaging and check Electrical connection Remove the transport bracketFirst Wash Cycle Precautions and General RecommendationsPreparation of the Washing Description of the Washing MachineSort the laundry Dyeing and bleaching Stain removalStarching Open the machine lid Loading the laundryDosage Detergents and AdditivesFilling up with detergents and additives Choice of the right detergents and additivesProgramme Selection Cleaning the Foreign Body Trap Detergent dispenser Draining Residual WaterWater inlet hose filter Check and clean regularly at least two or three times a yearWashing machine does not start, no lamp lights up Water inlet hosesWashing machine does not start, but the pilot lamp is on Washing machine stops during the programmeWater Stop fault may have been triggered by Water stop fault depending on modelSpecify Before contacting After-Sales ServiceRemoval of transport bracket Connect the water inlet hose Adjust the feetConnect the water drain hose Water stop anti-flooding systemValid Only For Great Britain And Ireland Fuse replacementPolarized Plugs e.g pin, 13 amp plug conforming to BS 1363A Freddo Cold GB S 800 TL1Appliance in Rinse Hold Rinse Hold buttonRapid button Half Load button

CONTENTS