Smeg S800TL1 manual Adjust the feet, Connect the water inlet hose

Page 16

Adjust the feet

Install the washing machine on a level surface, near to electrical, water and drain connections.

If the floor is uneven, adjust the feet (do not insert pieces of wood, cardboard etc. under the feet):

1.Loosen the locknut using the wrench provided.

2.Adjust the height of the foot by hand.

3.Retighten the locknut by turning it anti-clockwise.

Make sure that all feet are resting correctly on the floor and that the washing machine is perfectly level and stable (use a spirit level).

The washing machine can be installed in an area 40 cm wide and 63 cm deep.

Note: if you install the machine on thick carpet, adjust the feet to ensure that there is sufficient space under the machine for the air to circulate.

Connect the water inlet hose.

1.Carefully screw the water inlet hose onto the tap by hand.

2.Make sure there are no kinks in the hose.

3.Check water-tightness of tap and washing machine connections by turning the tap completely on.

If the hose is too short, replace it with a suitable length of pressure resistant hose (minimum 1000 kPa - EN 50084 approved type).

Periodically check the hose for brittleness and cracks.

Replace if necessary.

The washing machine can be connected without a non-return valve.

For Great Britain & Ireland only:

1.Carefully screw both water inlet hoses:

• hot (see A) fill hose,

• and cold (see B) fill hose.

The warm water inlet temperature must not exceed 60° C.

A

B

GB 16

Page 15 Page 17
Image 16
Page 15 Page 17
Contents Contents Before Using the Washing Machine Install the washing machineRemove the packaging and check Electrical connection Remove the transport bracketPrecautions and General Recommendations First Wash CyclePreparation of the Washing Description of the Washing MachineSort the laundry Dyeing and bleaching Stain removalStarching Loading the laundry Open the machine lidDetergents and Additives DosageFilling up with detergents and additives Choice of the right detergents and additivesProgramme Selection Cleaning the Foreign Body Trap Draining Residual Water Detergent dispenserCheck and clean regularly at least two or three times a year Water inlet hose filterWater inlet hoses Washing machine does not start, no lamp lights upWashing machine does not start, but the pilot lamp is on Washing machine stops during the programmeWater stop fault depending on model Water Stop fault may have been triggered byBefore contacting After-Sales Service SpecifyRemoval of transport bracket Adjust the feet Connect the water inlet hoseWater stop anti-flooding system Connect the water drain hoseValid Only For Great Britain And Ireland Fuse replacementPolarized Plugs e.g pin, 13 amp plug conforming to BS 1363A GB S 800 TL1 Freddo ColdRinse Hold button Appliance in Rinse HoldRapid button Half Load button
Top Page Image Contents