Smeg LSE 146 manual Installing the Washing Machine, Using the Washing Machine

Page 8

8

INSTALLING THE WASHING MACHINE

CONNECTING TO THE MAINS ELECTRICITY SUPPLY

 

Make sure that the voltage indicated on the identification plate

9

attached to the inside of the filter door corresponds to that of the

 

mains supply (fig. 9).

 

All cut-outs, electric wiring and mains sockets must have a rating such that ena-

 

bles them to support the maximum load indicated on the identifi cation plate.

 

Once the appliance has been installed, it must be connected to the mains supply

 

through a single-pole switch.

 

The mains supply to which the appliance is connected must be fi tted with an

 

earthing system. If this is not the case, the manufacturer will not be held liable

 

for any incidents that may occur (fi g. 10).

10

If the mains socket to which the appliance is connected is faulty or unsuitable,

 

it must be replaced by a qualifi ed electrician.

 

The washing machine must not be connected to the mains supply using indirect methods such as extension leads or multiple adapters.

During maintenance work, the washing machine must be disconnected from the mains electricity supply.

Do not insert or remove the plug from the mains socket with wet hands.

If the power supply cable is damaged in any way, contact the appropriate spe- cialised service centre.

The plug used to connect the machine to the power supply must never be

xed behind the machine, but must be in a position easily accessible in an emergency.

USING THE WASHING MACHINE

RECOMMENDATIONS PRIOR TO USE

Attention: Before running the machine loaded for the first time, we re-commend that you run a short washing cycle with the machine empty.

This makes it possible to check operation of the machine and clean the drum.

Each time you use the machine:

check that all water connections are tight, the drain hose is positioned correctly (see connection to the water supply) and the supply tap is open.

make sure that your hands are dry, then insert the plug into the power sock- et.

divide the washing according to fabric type (check the labels on the clothes).

check that the clothes to be washed have nothing in their pockets that might damage the washing, the washing machine or the fi lter.

Closed

Open

 

11

 

12

GB

SM2706

Image 8
Contents Model LSE GB English Contents EnglishNever dry unwashed items Do not overload the washing machineFor WASHER/DRIER Versions only Description of the Appliance Do not expose the ap- pliance to atmospheric agentsInstalling the Machine According to ModelLevelling the Washing Machine Connection to the Water Supply System1.00 MPa 0.5 10 bar Water outletInstalling the Washing Machine Using the Washing MachineConnecting to the Mains Electricity Supply Recommendations Prior to USEUsing the Machine USE of DetergentsInstructions for mould and damp HOW to Remove Some StainsInternational Clothing Care Symbols Maintenance Cleaning the Washing MachineCleaning the Filter May cause damage. fig.20Resolving Problems Main Functions of the Washing Machine Model LSE Wash CycleOptional Functions Using the WASHER/DRIER Programme Table QuickDaily WashTechnical Characteristics RinseRecommended Drying Quantities and Times Type of fabric Time Type of dryingSM2706 Page 461307904 GB